500 Watt Ka-Band Antenna Mount High Power Amplifiers

PERFORMANCE SPECIFICATIONFREQUENCY RANGEOUTPUT POWERGAINParametersPeak PowerXTD-500Ka530.0 to 31.0 GHzCW PowerXTD-500KaL5Traveling Wave Tube 500W (57 dBm) Peak 500W (57 dBm) CWRated Power @ Amplifier Flange 250W (54 dBm) CW 435W (56.4 dBm) CWLinear Power 240W (53.8 dBm) CW 240W (53.8 dBm) CWLarge Signal (minimum)Small Signal (minimum)Attenuator range (0.1 dB steps)Maximum SSG Variation OverAny Narrow BandFull BandSlope (maximum)Stability, 24 hr. (maximum)Stability, Temperature (maximum)INTERMODULATION (maximum)with two equal carriersHARMONIC OUTPUT (maximum)SPECTRAL REGROWTH OQPSK(1.0 Symbol rate from carrier)AM/PM Conversion (maximum)NOISE POWER (maximum)Transmit BandReceive BandGROUP DELAY (maximum)BandwidthLinear70 dB70 dB30 dB0.80 dB per 60 MHz2.5 dB± 0.05 dB/MHz± 0.25 dB± 1.0 dB at any frequency-25 dBc at linear power,2.6 MHz separation relative to combined power-15 dBc(-60 dBc with optional filter)-30 dBc at linear power1.9 deg/dB rated linear power-75 dBW/4 kHz-150 dBW/4 kHzAny 60 MHz0.01 nS/MHzParabolic 0.001 nS/MHz 2RippleRESIDUAL AM NOISE (maximum)SPURIOUS (In band) Linear0.5 nS/Pk-Pk-50 dBc to 10 kHz-20 (1.5 + logf) dBc 10 to 500 kHz-85 dBc above 500 kHz-60 dBcPHASE NOISE (maximum) 10 Hz -32 dBc100 Hz -62 dBc1 kHz -72 dBc10 kHz -82 dBc100 kHz -92 dBc1 MHz -102 dBc10 MHz -112 dBc100 MHz -112 dBcVSWRInput (maximum) 1.3:1Output (maximum) 1.3:1TECHNOLOGYXTD-500Ka5/KaL5

BLOCK DIAGRAMOUTLINE DRAWINGDIMENSIONSINCHESCENTIMETERSL 22.25 56.52H 9.50 24.13W 10.25 26.04Typical Weight = 58 lb (26.31 kg)XTD-500Ka5/KaL5TECHNOLOGY

PRIME POWER90 to 264 Max.47 to 66 Hz, single phase1400 VA Typical0.95 Min. Prime Power FactorENVIRONMENTNONOPERATING TEMPERATURE RANGEOPERATING TEMPERATURE RANGEHUMIDITYALTITUDESHOCK AND VIBRATIONCOOLING-50°C to +70°C-40°C to +60°CUp to 100% Condensing10,000 feet MSL max. with standard adiabaticderatingNormal TransportationForced Air (self cooled)HeadquartersComtech Xicom Technology, Inc.3550 Bassett StreetSanta Clara, CA 95054USAPhone: +1-408-213-3000Fax: +1-408-213-3001email: sales@xicomtech.comWeb: www.xicomtech.com. . . . . . . . . .INTERFACEOPTIONSTypeFunctionLOCAL CONTROL Prime Power ON/OFF Local/RemoteLOCAL STATUSPower Supply ON/OFFTri-Color LED:Fault: RedHV ON: GreenHV ON/OFFStandby: Continuous AmberFTD: Flashing AmberREMOTE CONTROL HV ON/OFF RF Inhibit (HV OFF)RF AttenuationHeater StandbyFault ResetConstant PowerREMOTE STATUS HV On Heater/Beam HoursDISCRETE STATUSRF MONITOR PORTINTERFACERF Output PowerReflected PowerFilament Time DelayHelix VoltageFault IdentificationTWT TemperatureHelix CurrentSummary Fault (2X Form C Dry Contact Closure)-40 dB Coupling Value (approx)Serial RS-232/422/485Ethernet• Harmonic Filter (0.25 dB output power reduction)• WR-34 Waveguide Output or Input• Alternate Frequency Coverage• Remote External Controller• 1:1, 1:2, 1:N Redundancy• Phase Combined• L-Band Block Upconverter• UnlinearizedEuropean Sales OfficeComtech Xicom Technology Europe, LTD4 Portland Business CenterManor House LaneDatchetBerkshire SL3 9EGUnited KingdomPhone: +011 44 (0) 1753 549 999Fax: +011 44 (0) 1753 549 997email: sales@xicomeurope.comWeb: www.xicomtech.com. . . . . . . . . .Singapore Sales OfficeComtech Xicom Technology150 Cecil Street#08-02Singapore 069543Phone: +011 65 6325 1953Fax: +011 65 6325 1950email: asiasales@xicomtech.comWeb: www.xicomtech.comTECHNOLOGYDocument XTD-500Ka5/KaL5 Rev 4, 08/01/2011© 2011Note: Technical specifications are subject to change without notice. Pleasecontact Xicom Technology before using this information for system design.