Clutch Puller

More documents

Recommendations

Info

Fan Spanner Wrench (Suzuki) p/n: 0644-340 Usage: Hold fan in place during disassembly and assembly. Fig. 11 AE104 Engine Stand p/n: 0644-079 Usage: Hold engine during assembling/disassembling. Fig. 12 Pinion Shimming Tool (650 and 700 cc Engines) p/n: 0644-055 Usage: Determine size and number of pinion gear shims. Fig. 13 AE079 AE073 Water Pump Bearing & Seal Kit p/n: 0644-084 Usage: Remove/install crankcase water pump bearings and seals. Fig. 14 AE080 Oil Seal Installation Tool p/n: 0644-219 Usage: Install the oil seal on the water pump driveshaft on the 440, 550, 580, 650, 700, 800, and 900 cc Arctic Cat engines. Fig. 15 Blind-Hole Bearing <strong>Puller</strong> p/n: 0644-381 Usage: Remove small and large blind bearings on all models. Fig. 16 AE130 0644-381 5
Rigid Hone Stone Set (2.7-4.1 in.) p/n: 0644-043 Usage: Replacement stones for Cylinder Hone Set (p/n 0644-041). Fig. 17 6 AE068 Ball Hone p/n: 0644-290 (60-64 mm) p/n: 0644-291 (65-70 mm) p/n: 0644-292 (72-74 mm) p/n: 0644-293 (76-83 mm) p/n: 0644-294 (83-88 mm) Usage: Deglaze Nicosil plated cylinders. All are 320 grit and are recommended for reconditioning all Arctic Cat snowmobile engine cylinders (1976-2000). Fig. 18 Ignition Test Plug p/n: 0144-306 Usage: Test engine ignition. Fig. 19 AE065 AE045 Angle Finder p/n: 0644-097 Usage: Identify levelness and pitch. Fig. 20 Engine Timing Gauge p/n: 0144-009 Usage: Static time engines without CDI ignition. Fig. 21 Timing Light p/n: 0644-296 Usage: Check ignition timing. Fig. 22 AE090 AE031 AE054
Page 1 and 2: ® ARCTICCAT Effective Date: May, 2
Page 3 and 4: 2 TABLE OF CONTENTS Accessory Adapt
Page 5: Flywheel Spanner Wrench p/n: 0144-0
Page 9 and 10: Oil Injection Usage Tool p/n: 0644-
Page 11 and 12: EFI Throttle Cable Jam Nut/Oil- Inj
Page 13 and 14: Throttle Position Sensor (TPS) Adju
Page 15 and 16: Replacement Rivnuts p/n: 0623-557 (
Page 17 and 18: Shock Spanner Wrench p/n: 2604-878
Page 19 and 20: Inflation Needle p/n: 0744-020 Usag
Page 21 and 22: Track Stud Hole Drill (7 mm) p/n: 1
Page 23 and 24: Clutch Puller (Comet) p/n: 0644-096
Page 25 and 26: Reverse Gear Adjustment Gauge p/n:
Page 27: Printed in U.S.A. ®Trademarks of A

Clutch Puller

Create successful ePaper yourself

Delete template?

Save as template?