EasyMold Silicone Rubber B.pdf - Environmental Technology Inc

More documents

Recommendations

Info

Material Safety Data SheetProduct Name: EasyMold Silicone Rubber Part BProduct Codes: 33720, 33730 Revision Date: 9/17/2010Precautions for safe handling:Spilled substance increases risk of slipping.Precautions against fire and explosion:Observe the general rules for fire prevention.Conditions for storage rooms and vessels:None known.Advice for storage of incompatible materials:Not applicable.Further information for storage:Keep container tightly closed. Store in a dry and cool place.8. Exposure Controls and Personal ProtectionVentilation:Use with adequate ventilation.Local exhaust:Not necessary.Personal protection equipment (PPE)Respiratory protection:Respiratory protection is not normally required.Hand protection:Recommendation: Any liquid-tight rubber or vinyl gloves.Eye protection:Recommendation: Safety glasses with side shields.Other protective clothing or equipment:Additional protective clothing or equipment is not normally required. Provide eye bath andsafety shower.General hygiene and protection measures:When handling, do not eat, drink, smoke or apply cosmetics. Wash thoroughly after handling.9. Physical and Chemical PropertiesAppearance:Physical state / form: liquidColor:blueOdor:odorlessSafety parameters:Method:Melting point / melting range: not determinedBoiling point / boiling range: not applicableFlash point: > 300 °C (> 572 °F) (ISO 2592)Ignition temperature: > 450 °C (> 842 °F) (DIN 51794)Lower explosion limit (LEL): not applicableUpper explosion limit (UEL): not applicableVapor pressure:not determined4
Material Safety Data SheetProduct Name: EasyMold Silicone Rubber Part BProduct Codes: 33720, 33730 Revision Date: 9/17/2010Density: 1.01 g/cm³ at 20 °C (68 °F), at 1013 hPa (DIN 51757)Water solubility / miscibility: virtually insoluble at 20 °C (68 °F)pH-Value:not applicableViscosity (dynamic):approx. 800 mPa.s at 20 °C (68 °F) (BROOKFIELD)Thermal decomposition:> 200 °C (> 392 °F)10. Stability and ReactivityGeneral information:If stored and handled in accordance with standard industrial practices no hazardous reactionsare known.Conditions to avoid:None known.Materials to avoid:None known.Hazardous decomposition products:If stored and handled in accordance with standard industrial practices and local regulationswhere applicable: none known . Measurements have shown the formation of small amounts offormaldehyde at temperatures above about 150 °C (302 °F) through oxidation.Further information:Hazardous polymerization cannot occur.11. Toxicological InformationGeneral information:Toxicological testing has not been conducted with this material.12. Ecological InformationInformation on elimination (persistence and degradability)Biodegradation / further information:Biologically not degradable.Further information:Separation by sedimentation.Insoluble in water.Further information:Bioaccumulation is not expected to occur.Ecotoxicological effects:Evaluation on basis of physical-chemical properties: No expected damaging effects to aquaticorganisms.Effects in sewage treatment plants (bacteria toxicity: respiration-/reproduction inhibition):According to current knowledge adverse effects on water purification plants are not expected.Other harmful effects:None known.5
Page 2 and 3: Material Safety Data SheetProduct N
Page 6 and 7: Material Safety Data SheetProduct N
Page 8: Material Safety Data SheetProduct N

EasyMold Silicone Rubber B.pdf - Environmental Technology Inc

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?