SPRAY-GUN WASHER IWK H2O Mod. H20 - Anest Iwata

1.3 DESCRIPTIONSPRAY-GUN WASHER IWK H2O Mod. H2OThe Spray-gun washer basically consists of a steel container (see fig.1) housing:• A stainless steel tank to collect the used water (pos.2 fig.1).• A grill (pos. 6G fig 1) positioned on the stainless steel tank.• A nebulizer (pos.22 fig.1).• A small pump (pos. 21 fig.1).• A brush connected to the water mains (pos.36 fig.1).• An air distributor to mix the water with the flocculant powder (pos. 35 fig.1).• A washing tank drain valve (pos.30 fig.1).• A kit to separate the paint from the water (pos. W50 - W51 - W52 - W53 - fig.1).• A hose (pos.23 fig.1) for the intake of water for the nebulizer.• A hose (pos.24 fig.1) for the intake of water for the small pump.• A lower door.From the upper control panel, the operator can control:• The clean water pump (pos.19 fig.1)• The clean water nebulizer (pos. 18 fig.1),• The clean water from the water supply of the company (pos.18C fig.1).• The air regulator to mix the used water with the flocculant powder (pos.1 fig.1).SPRAY-GUN WASHER DESCRIPTION ( See figure 1 ):1 Flow regulator2 Stainless steel tank3 Lower door magnet4 Blow gun supply hose.4A Blow gun.6G Stainless steel grill.10 Compressed air outlet fitting for air gun.11A Lower door.12 Air inlet fitting with filter.18 Nebulizer control lever.18C Water control lever to the main water supply.19 Small pump control lever.21 Small pump22 Nebulizer.22C Water outlet fitting.23 Nebulizer supply hose.23C Main water supply inlet fitting.23R Water throttle valve (to be connected to the 23C fitting and the main water supply).24 Pump supply hose.30 Wash tank drain valve.35 Air distributor .36 Washing brush74 Earthing cable.W-50 Pre-filter bag.W-51 Filter bag.W-52 Small perforated container.W-53 Large container for regenerated water.6