DEEP SEA ELECTRONICS PLC

DSE Model 5220 Automatic Mains Failure & Instrumentation System Operators Manual7.1.2 EDITING AN ANALOGUE VALUEPress the button to enter edit mode. This is indicated by the flashing parameter. In this example, entering editmode will cause the 1.2 value to flash.When in edit mode, pressing the + or – buttons will adjust the parameter to the desired value. Press the button to ‘save’ the value. The value will stop flashing to confirm that it has been saved.To select another value to edit, press the + button :The next parameter being displayed in this exampleis the Low Oil Pressure shutdown, being indicatedby the illuminated oil can.The shutdown symbol is indicating that it isthe shutdown (trip) parameter that is beingdisplayed.Continuing to press the + or – buttons will cycle through the adjustable parameters in the following order :Config’ Section Parameter Type Icons displayedAnalogue senders Low Pressure Pre AlarmLow PressureHigh TemperatureHigh TemperatureFuel Level %TripPre AlarmTripPre AlarmCalendar Date/time Date/timeTimers Mains transient delay Timer (secs) 1Start delay Timer (secs) 2Preheat Timer (secs) 3Crank attempt Timer (secs) 4Crank rest Timer (secs) 5Safety delay Timer (secs) 6Overspeed overshoot Timer (secs) 7Warming up Timer (secs) 8Transfer delay Timer (secs) 9Return delay Timer (secs) 10Cooling run Timer (secs) 11E.T.S.(Energise to stop) solenoid hold Timer (secs) 12Mains (utility) supply Mains Low Voltage Trip VMains High Voltage TripVMains Low FrequencyTripMains High FrequencyGenerator output Generator Under Voltage L1-N Trip VGenerator Under Voltage L1-N Pre Alarm VGenerator Over Voltage Pre AlarmVGenerator Over Voltage TripVGenerator Under FrequencyTripGenerator Under FrequencyGenerator Over FrequencyGenerator Over FrequencyTripPre AlarmPre AlarmDelayed Overcurrent % TripATrip24 057-012 5220 OPERATING MANUAL ISSUE 5.1 18/06/2007 AM