Baldwin Estate Price Book - Top Notch Distributors, Inc.

INTERIOR & ENTRANCE HARDWARETUBULAR LATCH INSTALLATION W/ALIGNING BUSHINGDrill .75˝ hole.* NOTE: IN SEPARATE MOUNTING APPLICATIONS,THE MINIMUM DISTANCE BETWEEN CENTER OFBOLTS IS 2.75˝.*This minimum distance is required to allow forproper clearance between latch bolt and mortise boltstrikes (T-Strikes).NOTE: Mortise bolt may be installed above or belowtubular latch, depending upon visibility.8474.000Alignment BushingDrill .625˝ hole.5097.000.NBack PlateUse of 8474.000 Aligning Bushing will facilitate installation of trim.Trim must be in alignment with latch and spindle to prevent binding.A. Install latch and strike per template instructions.B. Insert spindle through latch.C. Position 5097.009 Back Plates over spindle and insert 8474.000 Alignment Bushings.D. Center mark and install screws into back plates and remove 8474.000 Alignment Bushings.E. Install trim.MORTISE BOLT INSTALLATIONWhen installing mortise bolts, ALWAYS check width of Emergency Release Trim before drilling face bore. Standard bore is .625˝ (16mm) completely through door. Emergency Release Trim0406 and 0407 require a .5˝ (13mm) bore on outside face of door; a .625˝ (16mm) bore on inside face of door.IMPORTANT: When Emergency Release Trim is used, the turn piece spindle must be cut to extend no farther than halfway through the bolt.57