You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Linear Units Ordering<br />
Ordering Keys<br />
Linear Units with Belt Drive and Ball Guides<br />
WH40<br />
Your Code<br />
1 2 3 4 5 6<br />
Example WH04Z100 -01400 -01755 H L -0400<br />
1. Type of unit<br />
WH04Z100 = WH40 unit<br />
2. Maximum stroke (S max)<br />
- • • • • • = distance in mm<br />
3. Total length of unit (L tot)<br />
- • • • • • = distance in mm<br />
4. Drive shaft configuration 1<br />
A = shaft on left side without key way<br />
B = shaft on right side without key way<br />
C = shaft on left side with key way<br />
D = shaft on right side with key way<br />
Note! for ordering of options type EN, ES, KRG, RT, ADG and MGK, see accessory index on page 127.<br />
M55, M75, M100<br />
Your Code<br />
E = shaft on left side without key way and<br />
shaft on right side with key way<br />
F = shaft on left side with key way and<br />
shaft on right side without key way<br />
G = shaft on left side without key way and<br />
shaft on right side for encoder<br />
H = shaft on left side for encoder and<br />
shaft on right side without key way<br />
I = shaft on left side with key way and<br />
shaft on right side for encoder<br />
J = shaft on left side for encoder and<br />
shaft on right side with key way<br />
L = shaft on both sides without key way<br />
M = shaft on both sides with key way<br />
5. Carriage configuration<br />
N = single standard carriage<br />
L = single long carriage<br />
Z = double standard carriages<br />
6. Distance between double carriages<br />
- 0000 = always for single carriages<br />
- • • • • = distance in mm<br />
1 See below for the definition of shafts.<br />
Left Right Both<br />
1 2 3 4 5 6<br />
Example MF06B105 A 00 X 450 +S1<br />
1. Type of unit<br />
MF06B105 = M55 unit<br />
MF07B130 = M75 unit<br />
MF10B176 = M100 unit<br />
2. Type of carriages<br />
A = single standard carriage<br />
C = double standard carriages<br />
3. Distance between carriages (Lc)<br />
00 = for all single standard carriage units<br />
• • = distance in cm between carriages<br />
4. Drive shaft configuration<br />
R = shaft on the side as shown in picture<br />
Q = shaft on the side as shown in picture<br />
X = shaft on both sides<br />
5. Ordering length (L order)<br />
• • • = distance in cm<br />
6. Protection option 1<br />
+S1 = wash down protection<br />
1 Leave blank if no protection option required.<br />
R Q X<br />
201