Screw testing machines Torsion testing machines TesT - TesT GmbH

Model 210
Torsion test machines
Application:
The model TesT 210 is used for
tests for the determination of torque
and angle of rotation or torsion.
The area of application extends
from the simplest construction unit
examination up to the most complex
classical material testing.
The machine essentially consists of
3 components:
• 1 Torque transducer
• 1 Machine frame with regulated
drive and angle measurement,
• 1 Electronics for motor control
and recording of measurement
Depending upon measuring range
there are versions as table model
or models with worktable. For
the determination of the torque
static (Models 411 or 415) or dynamic
(Models 421 or 422) torque
transducers are used. Depending
upon application and measuring
range the sensors are equipped with
cone bearings for the protec-tion
against lateral loads.
For motor control and evaluation the
electronics model 810 or the PC card
record model 822 with the software
TesTWinner ® 922 is available.
Model 210S.500Nm with
device for axial load
Model 210S.1000 Nm.H with clamping length up to 2m
The dimensions of the torsion test machines are adapted to the requirements.
A driving motor
B metal hood for the drive
C safety hood with switches, adjustable
D torque transducer, implementation with flange
E carriage with cone bearings
F clamping device
G work table
H test specimen
I emergency stop switch
J table foot with integrated power electronics
L control lamp
Torsion test machine - Schematic depiction
5