MT/JIG USA - Rockler.com

More documents

Recommendations

Info

MT/JIG USASide AngledTenon1 Remove the lowerF clamp head andadjust the positionof the verticalguide as required.12 Tighten the boltwith the allen keyand refit the Fclamp head.3233 Rout the end ofthe timber parallelto the top plate orcut it at theappropriate angleon a snip-off saw.or4 Fit and clamp thetimber at thecorrect positionusing the set-upbar as shown onpage 11.Set the top plateposition as shownon page 12.Set the templatesas shown on page13.45 Set the depth ofcut and rout inincreasing depthsto complete thetenon as shownon page 14.455-15-
MT/JIG USAFront AngledTenon1 Adjust the tiltingback plate to theposition required.2 Tighten the twobolts with the hexkey.3 Rout the end ofthe timber parallelto the top plate orcut at theappropriate angleon a snip-off saw.123 34 Fit and clamp thetimber at thecorrect positionusing the set-upbar as shown onpage 11.Set the top plateas shown on page12.4orSet the templatesas shown on page13.45 Set the depth ofcut and rout inincreasing depthsto complete thetenon as shownon page 14.When angle isgreater than 20°move top F clampto its lower position.55-16-
Page 1 and 2: 34609MT/JIGUSARTD10000037AB
Page 3 and 4: MT/JIG USADescriptionof parts1Male
Page 5 and 6: MT/JIG USASAFETY PRECAUTIONS■ Alw
Page 7 and 8: MT/JIG USA2Assembly ofthe Top plate
Page 9 and 10: MT/JIG USAMarking outthe Tenon1 2 3
Page 11 and 12: MT/JIG USAFitting ofguidebushes-10-
Page 13 and 14: MT/JIG USASet CentreLine1 Release l
Page 15: MT/JIG USARoutingProcedure11 After
Page 19 and 20: MT/JIG USACutting theMortise11 Afte
Page 21 and 22: MT/JIG USADoweling1 Select and fit
Page 23 and 24: MT/JIG USAMT/JIG USASPARE PARTS DIA
Page 25 and 26: MT/JIG USAIMPORTANT!For use with Pl

MT/JIG USA - Rockler.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?