Fabrication and Installation Manual - Caesarstone

Honed and Textured Finish
Cleaning and Maintenance Please understand that Honed, textured and Motivo finishes will require more daily maintenance
than our polished finishes. Since there is more exposed surface area with honed finishes, metal marks, fingerprints and other signs of
daily living will show on these materials. Most of these marks can be easily removed with little effort and cleaning products such as
Soft Scrub ® Liquid Gel with Bleach. Rinse thoroughly with water.
Honed, Textured and Motivo materials may receive slight surface markings during transportation, fabrication, or installation. These
marks can usually be removed using the cleaning methods mentioned above.
Note: Under no circumstances should any type of stone-impregnating sealers be applied to any CaesarStone surface.
When fabricating any CaesarStone material with a honed finish, take care not to overpolish any edge details beyond the honed finish
on the slab face surface. This can normally be achieved by wet polishing using diamond granite or marble pads progressing only to a
400-grit level or until optimum result is obtained.
All CaesarStone fabrication requires fabricators to avoid modifying the factory polish on the face of the slabs. For all finishes, it is
recommended that a protective layer, such as tape or plastic, be applied to the slab face to prevent accidental damage to the factory
polish during fabrication and installation.
Note: A Special Care Considerations Form must be signed by the homeowner prior to purchasing these materials.
www.CaesarStoneUS.com
Fabrication Instructions 15