Legrand - Tehnounion

Mosaic TM
programme mechanisms
dimmer switches
784 01 784 02
784 10
Can be controlled remotely via non-illuminated pushbuttons,
each pushbutton thus being used to perform the dimming function
Come on at the lighting level set prior to the last switch-off
Pack Cat. No. Dimmer switches, 110-230 VA - 50 Hz
Without neutral, 2-wire 400 W
For controlling bulbs:
- 400 W incandescent or halogen, 230 VA
- 400 VA, ELV halogen with ferromagnetic or
electronic transformer
2 modules
1 784 01 White
Without neutral, 2-wire 600 W
For controlling bulbs:
- 600 W incandescent or halogen, 230 VA
- 600 VA, ELV halogen with ferromagnetic
transformer
2 modules
1 784 05 White
With neutral, 3-wire, 1000 W
For controlling bulbs :
- 1000 W incandescent or halogen, 230 VA
- 1000 VA, ELV halogen with ferromagnetic or
electronic transformer
5 LEDs for displaying the current level of the circuit
5 modules
1 784 02 White
1 784 04
Dimmer switch, 1-10 V
For on/off/dimming control of fluorescent tubes with
1-10 V electronic ballast
Max. control current: 40 mA
Max. power: 600 VA
2 modules
White
1 784 10
Auxiliary control for remote control dimmer
Remote dimming peripheral for local control of a
remote control dimmer that is some distance away
Used to control Lexic modular remote control
dimmers Cat. Nos. 036 60/71, requires a power
supply Cat No. 036 80 (see general catalogue)
2 modules
White
Mosaic TM
programme mechanisms
lighting environment controller
784 30 784 31
Pack Cat. No. Main controller 110-230 VA - 50 Hz
Particularly suitable for managing lighting
environments
in conference rooms, meeting rooms
restaurants, showrooms, etc.
Possible applications:
- Controlling 3 lighting circuits in a room
- Managing lighting environments by dimming
polychromatic red/green/blue or cold white/warm
white bulbs
Possible loads per circuit:
- 1000 W for incandescent and halogen 230 VA
- 1000 VA for fluorescent with 1-10 V ballast
- 1000 VA for ELV halogen with ferromagnetic or
electronic transformer
The total load for all 3 circuits must not exceed
2200 W
It is also possible to control Dali input ballasts
and 1-10 V ballasts
Can be remotely controlled via infrared using remote
control unit Cat. No. 784 31
Installation with neutral in box depth 50 mm
recommended (Cat. No. 801 24)
Use finishing plate Cat. No. 788 39 (White)
1 784 30 White
1 784 31
Auxiliary infrared remote control unit
For remote control of stored lighting
environments
Operates with 9 V battery (not supplied)
Table of loads: see general catalogue
• 47