2009 HB/HG Aspen/Durango HEV Supplement
2009 HB/HG Aspen/Durango HEV Supplement
2009 HB/HG Aspen/Durango HEV Supplement
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
84 WHAT TO DO IN EMERGENCIES<br />
(D) After Injecting TIREFIT Sealant:<br />
1. Allow the air pump to inflate the tire to the pressure<br />
indicated on the tire pressure label on the driver-side<br />
latch pillar. Check the pressure in the tire by looking at<br />
the Pressure Gauge (2).<br />
• If the tire inflates to at least 26 psi (1.8 bar) within 15<br />
minutes, proceed to Step 2 of this procedure.<br />
• If tire fails to inflate to 26 psi (1.8 bar) within 15<br />
minutes, perform the procedure steps described<br />
under “(G) Distributing TIREFIT Sealant to Better<br />
Enable Tire Inflation.”<br />
• Press the Air Pump Power Button (3) to<br />
turn OFF the TIREFIT kit.<br />
2. Remove the Speed Limit sticker from the top of the<br />
Sealant Bottle (1) and place the sticker on the steering<br />
wheel.<br />
3. Disconnect the Clear Sealant Hose (7) from the valve<br />
stem, reinstall the Yellow Cap on the fitting at the end of<br />
the hose, and place the TIREFIT kit in the vehicle.<br />
CAUTION!<br />
Failure to reinstall the Yellow Cap on the fitting at<br />
the end of the Clear Sealant Hose (7) can result in<br />
sealant contacting your skin, clothing, and the vehicle’s<br />
interior. It can also result in sealant contacting<br />
internal TIREFIT kit components causing permanent<br />
damage to the kit.<br />
(E) Securing TIREFIT Sealant in the Tire<br />
Drive the vehicle for approximately 5 miles (8 km) to<br />
ensure distribution of the TIREFIT Sealant within the tire.