2008 RT Caravan Owner Manual

344 STARTING AND OPERATING
Improper alignment will not cause vehicle vibration.
Vibration may be a result of tire and wheel out-ofbalance.
Proper balancing will reduce vibration and
avoid tire cupping and spotty wear.
TIRE CHAINS
Use only compact chains, or other traction aids that meet
SAE type “Class S” specifications. Chains must be the
proper size for the vehicle, as recommended by the chain
manufacturer.
NOTE: Do not use tire chains on a compact spare tire.
CAUTION!
To avoid damage to your vehicle or tires, observe the following
precautions:
• Because of restricted chain clearance between tires and
other suspension components, it is important that only
chains in good condition are used. Broken chains can
cause serious damage. Stop the vehicle immediately if
noise occurs that could indicate chain breakage. Remove
the damaged parts of the chain before further use.
• Install chains on the front wheels as tightly as possible
and then retighten after driving about 1 ⁄2 mile (0.8 km).
• Do not exceed 45 mph (70 km/h).
• Drive cautiously and avoid severe turns and large bumps,
especially with a loaded vehicle.
• If chains are used on an All Wheel Drive (AWD) vehicle,
they should be used on all four tires.
• Do not drive for prolonged period on dry pavement.
• Observe the tire chain manufacturer’s instructions on the
method of installation, operating speed, and conditions
for use. Always use the lower suggested operating speed
of the chain manufacturer if different than the speed
recommended by the manufacture.