Wind transducer Twin Fin - Hippopotamus

More documents

Recommendations

Info

WINDEnglish4 Electric installation4.1 Connections to the NX2 ServerIf you already have a Nexus Network i.e. a Server, it is more practical to connect thetransducer to the Server due to the single instrument cable installation. Note, set C71in Wind Data instrument to OFF (see Wind Data Manual)ServerTransducer4.2 Installing cableThe power cable is connected via a 3A fuse from the battery or at the boats fuse paneland direct to the instrument or Server. One red and one black power wire is included.Note, set in Wind Data instrument to C71 On (see Wind Data Manual)Always connect a 3 AMP fuse between Power supply and instrument.ScreenBlackGreenYellowWhiteRedTransducer3A Fuse12-5
EnglishWIND5 CalibrationIn order to get correct readings on your instruments, the transducer has to becalibrated. There are three things that has to be done:1. Enter the calibration values from the supplied calibration certificate into thecodes C56 to C62.2. Enter the misalignment of the transducer in calibration code C553. Make sure the calibration for wind speed in C54 is set to 1.70For information of how to enter the calibration values, se the instrument manual.6 SpecificationsTransducer cable 25 mPower suppIy 12V DC (10-16V)Power consumption 0,24 WCurrent consumption: 20mA @12VWind speed range 0.9-90 knots, 0.5-50 m/sAngle Accuracy Better than ± 2°Speed Accuracy ± 5%Temperature range Operating -5ºC to +70ºCStorage -20ºC to +80ºCWeight 260 g.6.1 Dimensions:12-6
Page 1 and 2: performance by NEXUS NETWORKWind tr
Page 3 and 4: EnglishWINDThis manual is written f
Page 5: EnglishWIND3.1 Mounting step by ste
Page 10 and 11: WINDEnglish12-9

Wind transducer Twin Fin - Hippopotamus

Create successful ePaper yourself

Delete template?

Save as template?