Thermofoil_Spiral_2-2011 - Northern Contours

Portabella Series - Traditional MiterProduct Specifications• TM400 is available in Caramel Glazed Bisque thermofoilwith PNL1 or PNL3.• TM401 is available in Walnut Glazed Summerflame orBlonde Maple thermofoil with PNL1 or PNL3.• MF100 and MF200 are profile wrapped with finishedpaper and are only available with acrylic inserts.• Portabella door and drawer front orders have a leadtimeof 6 business days. Orders that also include glazedaccessory items have a leadtime of 10 business days.• One square foot minimum charge will apply for eachpiece.• Standard panel grain direction: vertical for doors,horizontal for drawer fronts. Vertical direction availableon drawer fronts if noted.• All accessory items are available in identical matchingfoils except MF100 and MF200.• Hinge cup hole depth cannot exceed 11.5mm on theMF100.• Slab drawer fronts are available. Standard graindirection is horizontal. Minimum size is 3” x 3”.• The following accessory items are available glazed:Base, Colony, Regal (with rope or dentil detail), Royal,Designer and Windsor Mouldings, Fluted Fillers,Rosette 237 and Valances.• Trained craftsman manually apply the glazed finish onall matching accessory items. Due to this manualfinishing, the build up of glaze may vary from one part toanother. This variance is considered an acceptablecharacteristic of glazed finishing and parts will not bereplaced or redone due to these variations.• Fingerpulls, mullions, specialty lazy susan doors, ormulti-panel doors are not available for this series.• Portabella styles are produced as shown. Variation oninside and outside profiles is not available.• Portabella products are only available from our KYproduction facility.• The following grid outlines the minimum and maximumdimensions for Traditional Miter doors, drawer fronts,and frames using standard stile and rail dimensionsshown.TM400 SlabTM401 SlabDoor withPNL3MinimumDoor withPNL1MinimumDrawer Frontwith PNL3MinimumDrawer Frontwith PNL1MinimumMaximum*Doors and Fronts Width Height Width Height Width Height Width Height Width HeightTM400 9 9 7 7 6.5 6.5 5.5 5.5 30 80TM401 9 9 7 7 6.5 6.5 5.5 5.5 30 80MF100 and MF200 - - 7 7 - - 5.5 5.5 30 80Frames Minimum Maximum*TM400F 7 7 30 80TM401F 7 7 30 80MF100 and MF200 7 7 30 80All dimensions are in inches*While our manufacturing capabilities allow us to go to a height of 80”, product over 60” long will not be covered by ourwarranty. We highly recommend using multiple doors instead. If you do order unwarranted product over 60”, we recommendusing additional hinges to help control any warping that may occur. 30” is our absolute maximum width.14866.344.8132 • www.northerncontours.com