Download (0.1 MB) - Prolyte Group

More documents

Recommendations

Info

Use :Lifting brackets shall be used to lift or suspend trusses with corresponding centre-to-centre distancesof truss main chords.Depending on local regulations the WLL shall be adjusted when used to move loads above peopleLifting brackets shall be positioned in the node point of the webbing of the truss. If this is not possiblethe following max. truss loading can be applied.X/H30D/V and X/H40D/V truss > full load on truss is allowed when positioned within 100mm from anode point.S36R/V, S52F/V/SV, S66R/V, > max 2000kg per support point is allowed when positioned within100mm from a node point.Make sure all bolts are tightened.In case of suspended from a steel wire make sure item 6 (bolt for lifting eye) is secured againstunintended loosening.Lifting brackets can be used up-side-down .The lifting eye can be mounted between the clamps. In order to do so, uptight the bolt, replace thebolt up-side-down and re- connect the lifting eye. Secure lifting eye against unintended loosening bydamaging the bolt wire thread or drilling a hole and putting a split pin in.Never exceed the max. WLL as embossed on the aluminium extrusion (item 1).Prolyte Products Group, industriepark 31, 9351 PA leek, The Netherlandswww.prolyte.com – Phone +31-594-851515page 2 van 3
Warning ! :lifting brackets shall only be used in a vertical line with its suspension !Warning ! :In case of questions contact your local dealer or ProlyteProlyte Products Group, industriepark 31, 9351 PA leek, The Netherlandswww.prolyte.com – Phone +31-594-851515page 3 van 3
Page 1: PART 2: MANUAL FOR LIFTING BRACKETS

Download (0.1 MB) - Prolyte Group

Create successful ePaper yourself

Delete template?

Save as template?