Resulting Peel Ply Surfaces

More documents

Recommendations

Info

Thermoplastic Dual AdhesiveApproach to BondingLocal heating to melt film but not substratesCarbon/PEEK laminateLower melting point PEI filmco-molded with CFRPAdditional PEI layer
Open Time is the EnemyRef.: Henkle/Loctite Hysol EA 9394 Open-Time Considerations document• A freshly energized surface will try to stabilizeover time and subsequently lose the desiredeffect• The surface also takes on moisture and other low-energy contaminants when left exposed to the normalshop/clean-room environment• Amine-cured epoxy adhesive left open on thesurface for extended time may also be affectedby the environment (H 2 O & CO 2 )• Amine Carbonate formation can inhibit most room-temperature curing epoxy adhesive systems
Page 1 and 2: Welcome to Today’s s SME WebinarA
Page 3 and 4: Some Adhesively BondedComposite Str
Page 5 and 6: Bonding Definitions:• Secondary B
Page 7 and 8: Bond Failure Modes• Adhesive Fail
Page 9 and 10: Bond Failure Modes• Substrate fai
Page 11 and 12: Structural Adhesives• Modified Ac
Page 13 and 14: • PastesLiquids, Pastes, & FilmAd
Page 15 and 16: Carriers Used w/Film & Paste Adhesi
Page 17 and 18: Bonding to Honeycomb CoreAdhesive f
Page 19 and 20: • Goal:Surface Preparation ofTher
Page 21 and 22: What about Peel-Ply Ply Surfaces?
Page 23 and 24: Resulting Peel Ply SurfacesRef: Har
Page 25 and 26: Surface Free-Energy ExchangeIf the
Page 27 and 28: Surface Preparation ofThermoplastic
Page 29 and 30: Cleaning the Freshly EnergizedCompo
Page 31: Using an ApplicationTemplateTemplat
Page 35 and 36: Bondline Thickness ControlPrecise .
Page 37 and 38: Uniform Clamping Pressure• Unifor
Page 39 and 40: Effect of Different Fiber Forms at
Page 41 and 42: Effect of Different Fiber Forms at
Page 43 and 44: SummaryApply uniform clamping press

Resulting Peel Ply Surfaces

Create successful ePaper yourself

Delete template?

Save as template?