Raptor 700R Dyna FS Ignition (06-10) - Two Brothers Racing

More documents

Recommendations

Info

4-position connector forPC/Laptop programming3-position connector forCurve Selector Switch4 wires terminated withfemale bullet connectorsPURPLE = <strong>Two</strong>-step/low-side Launch Rev Limiter, requires a seperate switch (not included). Ground thiswire to activate the limiter. Use programming software to adjust the launch rpm.GREEN = Tach output, 1 pulse per rev, 12VBLUE = Programmable Speed Switch, 2 AMP MAX(referenced as "RPM Switch 1" in PC software)WHITE = Programmable Speed Switch, 2 AMP MAX(referenced as "RPM Switch 2" in PC software)NOTE1: White and Blue power switches can be programmed individually or together. Can be used to turnon a shift light, or activate a small solenoid, or switch a Bosch style relay for even heavier loads.NOTE2: The ignition will ground the White or Blue white inside the CDI when the pre-programmed RPMis achieved.2801312CDYNATEK 164 S. Valencia St., Glendora, CA 91741 800-928-3962 www.dynaonline.com
Picture1: Battery Ground.Picture2: Crank Pickup intercept connectors.Picture3: Expose the Yellow TPS signal wire.Picture4: Crimp the T-tap connector until it clicks.2801312CDYNATEK 164 S. Valencia St., Glendora, CA 91741 800-928-3962 www.dynaonline.com
Page 1 and 2: Dyna FS Ignition DFS 7-21P2006+ Yam
Page 3: DYNA FS / YAMAHA RAPTOR 700R - IGNI

Raptor 700R Dyna FS Ignition (06-10) - Two Brothers Racing

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?