Event Plus 60 Technical Specification Sheet (503.4 KB - Jands

108642010864201086420108642010864201086420108642010864201086420*_10864201086420F110864201086420108642010864201086420108642010864201086420108642010864201086420741852096310864201086420108642010864201086420ADDOFFOFF1086420\*10864201086420T E C H N I C A L S P E C I F I C A T I O N S H E E TEvent Plus 6060/120 CHANNELS / 24 ASSIGN MASTERSMEMORY LIGHTING CONTROL CONSOLEARCHITECTS AND ENGINEERS SPECIFICATIONSElectronicsThe lighting console shall provide control of up to 60 dimmer channels(120 in wide mode, 252 in superwide) via the industry standard USITTDMX-512/1990 protocol. The DMX output socket on the back panelshall be a 5-pin AXR. The output voltages shall conform to standardRS-485 balanced serial data transmission.The console shall have a MIDI In connection, the socket being astandard MIDI 5-pin DIN connector.The console shall have two preset faders and a flash button perchannel to allow direct manual control of stage lighting intensity. Theflash button shall house a light emitting diode (LED) to indicatechannel output level.The console shall utilise four (4) liquid crystaldisplays (LCDs) to provide parameter and editinginformation to the operator.The console shall have a memory capacity ofat least 128 Kbytes and shall be batterybackedto prevent memory loss whenswitched off. The battery shall have a life of atleast four (4) years.The console shall incorporate designtechniques and electronic filters to complywith the new Australian and European Uniondirectives on electrical safety and electromagneticcompatibility (EMC) (CE approved:EN50081-1, EN50082-1, EN60950).OperationThe console operating software shallincorporate diagnostic test routines thatexercise the different systems on the CPUcard. These test routines shall indicate to theoperator (using LEDs and/or displays) theresult (pass/fail) of the tests.The console shall display an error message tothe operator should the software malfunctionor be corrupted.ElectricalThe console shall operate from a single-phasesupply of 100 volts to 240 volts AC ±10%,with a supply frequency of 47 to 63 Hz.The console shall not draw more than 50 wattsof power from a normal GPO. The power inletshall be a switched and filtered IEC mainssocket with integral fuse, and shall be locatedon the back panel of the console.The console power supply shall be auniversal-type switched mode supplyrequiring no changing of internal links toaccommodate different supply voltages.MechanicalThe console shall be designed to be freestanding.The console shall be 1500mm wide 530mmdeep 110mm high.The console shall be constructed of 1.2mmsteel, and shall be provided with a removable1.2mm aluminium base for access to internalelectronics. All metal surfaces shall beproperly treated and finished in powdercoator zinc dichromate passivating.The control surfaces shall be scratchresistant0.25mm Lexan with legends reversesilkscreen printed from behind.PLUSPRESET 1PRESET 1PRESET 1PRESET 1Jands Electronics Pty Ltd 40 Kent Road Mascot NSW 2020 AustraliaPhone: +61 (0)2 9582 0909 Fax: +61 (0)2 9582 0999 Internet: jandsinfo@jands.com.auPRESET 2PRESET 2PRESET 2PRESET 2The sides and front arm rest of the console shall be constructed ofsteel-reinforced injection-moulded synthetic rubber.All operator controls and displays shall be provided on the top operatingsurface of the console.The chassis shall have sufficient ventilation holes to allow adequateconvection cooling of the power supply, provided the ambienttemperature does not exceed 40˚C (104˚F).The console shall be factory tested and cyclically burned-in for aminimum of 24 hours.The lighting control console shall be the JANDS EVENT PLUS 60.530 mmSpecifications subject to change without notice. Manufactured by Jands Electronics Pty Ltd ACN 001 187 837.Note: While all due care has been taken in the preparation of this document, Jands Electronics shall not be liable for any inaccuracies or omissions which may occur herein.ADDSOLOADDSOLOADDSOLOY 25 Z 26 a 27 b 28 c 29 d 30 e 31 f 32 g 33 h 34 i 35 j 36 k 37 l 38 m 39 n 40 o 41 p 42 q 43 r 44 s 45 t 46 u 47 v 48ADDSOLOADDSOLOADDSOLOw x y z / |_49 50 51 52 53 54 55 56 57 58 59 60A 1 B 2 C 3 D 4 E 5 F 6 G 7 H 8 I 9 J 10 K 11 L 12 M 13 N 14 O 15 P 16 Q 17 R 18 S 19 T 20 U 21 V 22 W 23 X 24109 110 111 112 113 114 115 116 117 118 119 12085 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 10861 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84CURSORD.B.O.SAMPLESLOW FASTRATEINHIBITLATCHCLEARSOLOHOLDASSIGNREVERSENORMALVALUEOFF ONASSIGNMASTERSASSIGNMASTERSGRANDMASTERADDSOLOP1 P2 MASTERCHASEEDITMEMORYFILEASSIGNPAGESTACKCLEARPATCHRECORDEXIT SETUPw x y z / \ | ♦ ∅ F2 F3 F4 F5 F6 F7 F8 F9 F10 F11 F12CROSSFADEGO BACK GO BACK GO BACKGO BACK GO BACK GO BACKGO BACK GO BACK GO BACK CROSSFADE GO BACK GO BACK GO BACK110 mm1500 mmPOWER 100 ~ 240VAC; 50 ~ 60Hz; 0.5A. FUSE: 2A M205/240VDESKLAMPDESKLAMP DMX-512 OUT MIDI INManufactured in Australia by: JANDS Electronics Pty Ltd ACN 001 187 83760/120 CHANNELS / 24 ASSIGN MASTERSMEMORY LIGHTING CONTROL CONSOLEEvent Plus 60TSS-EVENTPLUS60-0108-05