MC7205 MC7205 THX® Five Channel Power Amplifier

123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789123456789How to Connect the MC7205How to Connect the MC72051. Connect the MC7205 power cord to a live AC outlet.2. Prepare the loudspeaker hookup cables as follows:A. Carefully remove sufficient insulation from theloudspeaker cable ends to just fit within the bindingpost with no exposed wire accessible. Refer tofigure 1.B. If the cable is stranded, carefully twist the strandstogether as tightly as possible. Refer to figures 2 &3.Note: If desired, the twistedcable section can betinned with a solder ironto keep the strandstogether and/or attachappropriate connectorends.C. Insert the bare section of thecable end or connector intothe access hole, and tightenthe terminal nut clockwiseuntil the cable is firmlyclamped into the terminal sothe wires cannot slip out. Refer to figure 4.McIntosh MX132 A/V Control CenterMcIntosh SL-1 Power Sub-WooferD. Insert the bare section of the cable end or connectorinto the access hole, and tighten the terminal nutclockwise until the cable is firmly clamped into theterminal. Refer to figures 5 & 6.Note: The bare sections of the cable ends or the noninsulated part of the connectors must not be exposed oneither side of the terminal access hole.E. Repeats Steps A through D for each speaker cableused with the amplifier.3. Connect the loudspeaker cables to theappropriate output connectors, beingcareful to observe the correct polaritiesand install the protective coversthat were supplied. Refer to figure 7.4. Connect a single DB25 computer typecable from the multi-channel outputof a control center to the THX Inputconnector for all six audio channelsand power control.Figure 75. Connect the MC7205 Sub In/Out to the McIntosh SL-1Subwoofer THX input and a power control cable fromthe MC7205 Power Control Out to the SL-1 PowerControl In.Note: An optional hookup is to use discrete cables from aMcIntosh Control Center to inputs of the MC7205.Connect a “Y” adapter to the Control CenterSubwoofer Output, with one cable to the SL-1subwoofer THX input and a second cable to theMC7205 Sub In/Out jack. Connect a power controlcable from the Control Center Power Control Out to theMC7205 power control in jack and connect a powercontrol cable from the MC7205 Power Control Out tothe SL-1 Power Control In.To ACOutletSurroundRightSpeakerFrontRightSpeakerFrontCenterSpeakerSurroundLeftSpeakerFrontLeftSpeaker7