PlassOne Push Fittings - Peak Pipe Systems

15Technical DetailsCompression FittingsBodies & nuts in PolypropyleneO-rings in Nitrile Rubber (NBR)Reinforcing rings and toothedgrips are in Stainless SteelValvesBodies & nuts in PolypropyleneSplit rings in white PolyacetalOperating TemperaturesNot suitable for hot water,however, will withstand subzero temperatureThreadsInternal parallel threadExternal taper threadAll threads conform to:ISO 7BS 21-1973DIN 2999NEN 3258AS 1722 / Part 1 - 1975Chemical ResistancePlasson fittings are supplied,as standard, with Polyacetalsplit rings & NBR O-ringswhich are suitable for water.Operating Pressures andQuality CertificatesPlasson fittings are tested andapproved by WRAS in the UKto PN 16.Plasson have established aquality assurance system &achieved recognition underthe Quality StandardISO9001:2000.Operation in accordance withISO9001:2000 QualityAssurance system imposesstringent standards of controlthroughout themanufacturing process &selection of raw materialsThe products in this catalogue illustrate & describe the current state of their development,Plasson reserves the right to make such technical alterations as it sees fit to its products.Although every care has been taken in the preparation of the information, specifications,prices & other data included in this catalogue, we cannot rule out inadvertent errors oromissions and Plasson UK cannot be held responsible for such errors and omissions.plasson.co.uksales@plasson.co.uk