miros - Zumtobel

MIROS designAt a glance – the most common design mistakesGlare caused by projector withdirect scattered light or spill.When the projector is used properly,a special glare-protectionlouvre reduces this criticaleffect.Glare caused by mirror which isset at too shallow an angle (50°max.). This allows direct viewingof critically high luminance.Light cones do not overlap sufficiently.The floor is well lit butthe cones of light do not overlapsufficiently; light cones muststart to overlap at a height of atleast 2 metres.Glare due to scattered light.Light that is reflected by othermirrors, areas of glass or shinysurfaces may result in glare.Excessive irradiation will occur ifmirrors that are too small are used orif insufficient allowance is made forthe fact that the target area of themirror is reduced by tilting it relativeto the projector.Multiple irradiation aimed atilluminating a common surfacearea. The configuration shown inthe picture does not allow directillumination in the area underneaththe reflector.