Owner's Manual Prince® XL/Spool Gun - MK Products

Electric CableA seven-conductor control cable is used on the Prince ® XL gun. The gun endof the control cable is secured to the gun with a boot clamp and plugged intothe pot assembly and micro switch connectors. Slack is left in the electriccable as it exits the back of the gun to prevent cable breakage. The cabinetend has a seven-pin “W” clocked amphenol connector.Installing Spool Assembly(Kit P/N 005-0632)Loosen the screw that secures the conduit through access hole located ontop right rear handle with a 1/16” Allen wrench.Conduit Securing ScrewRemove conduit by pulling it out of the back of the gun.E-Ring Rear Wire GuideSpool LinerInstall spool liner, and secure with screw.Remove both rear handle screws, and secure spool canister with longerscrews provided.2 ScrewsSpool Gun SetupLoading Electrode WireUnscrew, and remove spool cover.Apply tension to drive rolls, so the wire will be picked up and fed through thecontact tip.Straighten out the first six inches of wire and push it through the liner.Jog the trigger until the wire is picked up by drive rolls and fed through thecontact tip.Hold the brake assembly back towards the top of the gun; load the spoolonto shaft with the wire coming off the bottom of the spool. Release thebrake assembly to rest on the wire surface.Replace the spool cover; making sure that the opening is over liner.Note: The brake assembly is designed to automatically control spooldrag and keep the wire from jumping off the spool.Disassembly of Prince ® XL/Spool GunRemove the trigger pin with punch and remove the trigger.Remove the six (6) handle screws and the spool adapter if installed.Remove the barrel from the gun, loosen the barrel taper lock assembly andslide towards the cup. Leave the barrel inserted in gun the body.Pull the handles apart.Prince ® XL/Spool Gun Owner's Manual - Page 2