mixer amplifier mx-amp 120e

POWERINPUT:350WATTSMixer-Amplifier - Front -Mixer-Amplifier - Rear -2 DE MX-AMP 120Eic audioMX-AMP 120E MIXER AMPLIFIER

Contentic audioPreperationUnpacking 5Safety Instructions 5General Informations 5Rack-Mounting 6Cooling 6Positioning Mixer Amplifier 6Device Functions- Rear side -230V Mains Connection 13100V/ 70V/8 Speaker Output 14Connection with One Zone 15Looping Devices 15AUX OUT 15Special CharacteristicsPaging Microphone 7Common Function 7IN (AUX/CD/TUNER/TAPE ) 15Microphone input 1 - 5 with Chinch - Jack 15Top view of all functions 16Inputs 7Outputs 7Further InformationTechnical Specifications 18Block Plugging Diagramm 19Index 20Device Functions- Front side -LED - Display 9ON/OFF -Switch 9Switch AUX/MIC 10Controller Bass and Treble 11Controller Master 113 DE

Preparationic audioUnpackingPlease note the unpacking instructions- Unpacking- Safety InstructionsSafety Informations- General InformationsPlease note the safety instructions before theconnecting the MX-AMP 120E- Rack-MountingGeneral Informations- CoolingCooling and instructions for the installation- Positioning Mixer AmplifierRack-MountingInformations about the right rack-mountingCoolingPlease note the ventilation - coolingguidelinesPositioning Mixer AmpifierPlease note the positioningof the Mixer - Amplifier4 DE

Preparationic audioUnpackingPlease verify if the following parts were delivered:line cordmounting foots pre-assembledSafety instructionsThe wires of the main power line have the followingcolours:GREEN and YELLOW:BLUE:BROWN :(E)(N)(L)As the colours of the wires in the mains lead of thisapparatus may not correspond with the colouredmarkings identifying the terminals in your plugproceed as follows:The wire which is coloured green and yellow mustbe connected to the terminal which is marked bythe letter E or by the safety earth symbol orcoloured green and yellow. The wire which iscoloured blue must be connected to the terminalwhich is marked with the letter N or colouredblack. The wire which is coloured brown must beconnected to the terminal which is marked with theletter L or coloured red.If a 13 Amp (B.S.1363) plug or any other type ofplug is used,a 5 Amp fuse must be fitted either inthe plug or at the distribution board.General InformationsDO NOT run microphone cables near mains,data, telephone or 100V line cables.DO NOT run 100V line cables near data,telephone or other low voltage cables.DO NOT exceed 90% of the amplifiers outputpower when using 100V line (speech only).DO NOT exceed 70% of the amplifiers outputpower when using 100V line (high levelbackground music).DO NOT use re-entrant horn loudspeakers forbackground music unless the loudspeaker hasbeen specifically designed for this purpose.AVOID jointing the microphone cable, whenthis is unavoidable make sure a good screenedconnector is used, e.g. XLR.ALWAYS use a balanced or floating lowimpedance microphone terminating into abalanced input on long microphone cable runs.ALWAYS use a mains grade double insulatedcable for the loudspeaker cable runs.ENSURE that all loudspeakers are in-phase.ENSURE that there are no short circuits on theloudspeaker line before connecting to theamplifier.5 DE

Special Characteristicsic audio- Paging Microphone Functions- Common Function- InputsPaging Microphone Functions5 Microphone inputs- OutputsCommon Function230V Mains ConnectionInputsCD, Tuner, TapeOutputs100V - Speaker Zone70V - Speaker Zone8ohm - For Monitor speakerAUX OUT7 DE

Device Functions- Front side -ic audioLED - DisplayDisplay for the activation- LED - DisplayON/OFF - Switch- ON/OFF - SwitchSetting - up the Mixer-Amplifier- Microphone ControllerMicrophone Controller-Switch AUX/MICController for the Microphone volume- Bass and Treble ControllerSwitch AUX/MIC- Master ControllerVolume Control of the acoustic signal sourceBass and Treble ControllerControl of the high and deep frequencyMaster ControllerControl of all Signals8 DE

Device Functions- Front side -ic audioLED - DisplayThe LED-Display shows the recording level of theMixer-Amplifier. The green LEDs show the range inwhich the MX-AMP could be operatedpermanently. The red LED shines only whenrunning in full conduction. This zone is notadvisable for long-term usage.LED - DisplayMX-AMP 120E MIXER AMPLIFIERON/OFF - SwitchWith this switch you turn on the apparat.Position I = apparat is onPosition 0 = apparat is offAfter turning the machine on, the LED is shiningblue. Before turning the machine on, the Mastercontroller should be set to a low volume.ON/OFF - SwitchMX-AMP 120E MIXER AMPLIFIER9 DE

POWERINPUT:350WATTSDevice Functions- Front side -ic audioMicrophone ControllerMicrophone ControllerWith the Microphone Controller you can controllthe volume of the separate microphones.Switch AUX/MICWith the switch you can controll the inputs of theconnected signal source.The source can be a CD-Player, Tape or acassette recorder.Switch AUX/MIC10 DEMX-AMP 120E MIXER AMPLIFIER

Device Functions- Frontside -ic audioBass and Treble ControllerWith this control you can adjust the reproduction ofdeep and high frequencies.The bass control lifts or lowers frequencies near to100Hz at 10dB. The treble-control has the sameeffect on at frequencies near to 10.000Hz.Bass and Treble ControllerMX-AMP 120E MIXER AMPLIFIERMaster ControllerThe master control drives the volume of all signalsbeing processed by the amplifier.Master Volume ControllerMX-AMP 120E MIXER AMPLIFIER11 DE

Device Functions- Rearside -- 230V Mains Connection- 100V Speaker Output- Connection with One Zone- Looping Devices- OUT- IN (CD, TAPE, TUNER/AUX)- Top view of all functions12 DE- Microphone input 1-5 with chinch-Jackic audio230V Mains ConnectionSelector to adapt the mains connection100V/70V/8ohm Speaker OutputTerminal for 100V/8ohm - speakersConnection with One ZoneDriving only one zoneLooping DevicesConnection to and from an other deviceOUTTerminal for OUT functionIN (CD,Tape Tuner/AUX)Terminal for Line IN devicesMicrophone input 1-5 w. chinch-JackConnection with XLR-JackSwitch for AUX/MICSelection of the sourceTop view of all functionsDiagram connected with all possible devices.

POWERINPUT:350WATTSDevice Functions- Rearside -ic audio230V Mains ConnectionThe amplifier is factory set at 230 V(AC) mainsvoltage.Mains Supply13 DE

POWERINPUT:350WATTSDevice Functions- Rear side -ic audioAUX OUTIN AUX/MICThese standard RCA phono sockets provide amixed output suitable for connection to a tape orcassette recorder.The equipment provides an auxiliary inputwhich may be used for connecting othersignal sources such as a Radio Tuner, CD orCassette player. The AUX/MIC input socketsare standard RCA phono, You can controll theAUX/MIC of the rear site of the amplifier.AUX OUT: TAPEIN: CD, Tuner, Tape (AUX)TAPE RECORDERTUNERCD15 DE

POWERINPUT:350WATTSDevice Functions- Rear side -ic audioOVERVIEW of all FunctionsTAPE RECORDER16 DETUNERCDMUSIC / SPEECH

FurtherInformationTechnical SpecificationsContaining all technical specificationsic audio- Technical Specifications- Block Plugging Diagram- IndexBlock Plugging DiagramCircut constructionIndexContent in alphabetical order.17 DE

FurtherInformationic audioTechnical SpecificationsTypeMixer AmplifierModellMX-AMP 120EMain Voltage AC 230V 50 / 60Hz ± 10%SupplyOutput power max.: 180WOutput power rated: 120WOutputsOutputs:MUSIC/SPEECH: 8ohm,70V,100VAUX OUT: 350mV 4.7KohmInputsMIC 1-5: 1mV, 250ohm balancedAUX: 200mV,47Kohm, unbalancedFrequency response MIC1~MIC5: 60Hz ~ 15KHz ± 3dBAUX/CD : 60Hz ~ 15KHz ± 3dBTotal harmonic distortion Less than1% at 1KHz, rated powerSignal to noise ratiol All VOLUME CONTROLS C.C.W. : 75dB below rated powerMIC1 ~ 5 : 60dB below rated powerAUX/CD) : 70dB below rated powerTone ControlsBASS : +/- 10dB at 100HzTREBLE: +/-10dB at 10KHzControlsMIC1~MIC5 volume controlAUX/CD volume controlMASTER volume controllTON controls (Bass,Treble)IndicatorsPower Indicator (LED), output level indicators (3 LEDS)AC power consumption 360 wattsDimensions (H xBxT) Desktop: 88 x 430 x 260 mmWeightMX-AMP 120E: approx. 9.5kgColourBlack18 DE

FurtherInformationic audioBlock Plugging Diagram19 DE

FurtherInformationINDEXBCCooling 6IInputs 7LLED-Display 9MMaster Controller 11Microphone Input 15Mains Connection 13OON/OFF - Switch 9Outputs 15RRack-Mounting 6SSpeaker Output 15Safety Instructions 5TUUnpacking 520 DEBlock Plugging Diagram 19Bass and Treble Controller 11Technical Specifications 18Top view of all functions 16ic audioic audiowww.ic-audio.com

… to make people listenic audio GmbHBoehringerstraße 14a68307 Mannheim /GermanyFon:+49(0)621/ 77096-0Fax:+49(0)621/ 77096-26www.ic-audio.comEmail: info@ic-audio.comic audio