Get the Instruction Book for this product - Breville

Operating your Breville ikon Blender continuedTo stop blending at any time, press the ‘Stop’button or the selected function button. The‘Power’ button can also be pressed, butthis will also turn the appliance off and allilluminations will go out.The maximum amount of ice cubes theblender can blend at any one time is 1standard ice tray or 250g.Step 9For ingredients that require short bursts ofpower, select the ‘Pulse’ function. The ‘Pulse’button will illuminate and remain illuminatedwhile the button is depressed. Press the ‘Pulse’button in short bursts until blending is complete.Use the ‘Pulse’ button when the food that isbeing processed is too thick or coarse tocirculate within the blender jug.Step 10At the end of use, always ensure the blender isturned off by pressing the ‘Power’ button on thecontrol panel. Then switch the appliance off atthe power outlet and unplug the cord. Ensurethe motor and blades have completely stoppedbefore attempting to move the appliance, orwhen the Breville ikon Blender is not in useand before disassembling, cleaning and storing.During the blending process, ingredients maystick to the side of the blender jug. To push thefood back onto the blades, press the ‘Power’button on the control panel and switch off atthe power outlet and remove the power cord.Remove the lid and use a plastic spatula toscrape down the sides of the jug. Replace thelid before recommencing blending.If any moisture or liquid appears on top ofthe motor base during blending, press the‘Power’ button on the control panel, switchoff at the power outlet and remove the powerplug. Remove the blender jug. Wipe the motorbase immediately with a dry cloth or papertowelling to absorb the liquid. Check theblending jug is correctly assembled.Overload protection systemThe motor is protected from burning out byan automatic, temperature operated, cut-outswitch. If the blender is overloaded or operatedcontinuously for too long, the motor mayoverheat. If this happens, the safety cut-outswitch will prevent the blender from operating.To operate the blender again, you must switchoff at the power outlet, unplug and allow tocool for approximately 30 minutes. Once themotor has fully cooled, it is ready for use again.9BBL550_IB_FA.indd 910/02/10 2:32 PM