89cm/98cm Ku-BAND Rx/Tx ANTENNA SYSTEM - General Dynamics

More documents

Recommendations

Info

General Dynamics SATCOM Technologies4096-62989cm/98cm Ku-BAND Rx/TxElevationAdjustment BoltReflector SupportTightencanister afterroughadjustmentFIGURE 2.Fine azimuthadjustmentScale forelevationadjustmentLOOSEN THIS BEFOREELEVATIONADJUSTMENT TYPICALBOTH SIDES15
General Dynamics SATCOM Technologies4096-62989cm/98cm Ku-BAND Rx/TxSECTION IVMAINTENANCE4.0 MAINTENANCE OVERVIEWAfter installation, the antenna requires only periodic inspection. It isanticipated that maintenance, if required, will be minimal and easilyhandled by a local or in-house maintenance staff.4.1 REFLECTORGeneral Dynamics reflector does not require any maintenance. The compositeconstruction of the reflector is virtually impervious to any damages that could becaused by weather or atmospheric conditions. It is only necessary to inspect forany physical damage done by vandalism or very severe weather conditions.Should any damage be detected to a portion of the reflector, contact theCustomer Service Department at General Dynamics for recommendationsinvolving reflector repair.4.2 MOUNT AND REFLECTOR SUPPORT STRUCTUREThe mount and reflector support structure supplied with this antenna is of steelconstruction and has a galvanized finish.If there are any signs of structural failure, the mount members that are damagedshould be repaired or replaced.4.3 FEED AND FEED SUPPORTThe feed support and feed rods should be inspected to insure that all hardware issecure. The feed/radio mounting bolts should be tight.The feed horn window should be inspected to insure that it is intact so that nomoisture can collect inside the feed horn.16
Page 1 and 2: 4096-629May 6, 2009ASSEMBLY MANUALR
Page 3 and 4: General Dynamics SATCOM Technologie
Page 15: General Dynamics SATCOM Technologie

89cm/98cm Ku-BAND Rx/Tx ANTENNA SYSTEM - General Dynamics

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?