Dishwasher

More documents

Recommendations

Info

Spray arms Check whether or not the holes for the upper and lower spray arms are clogged. If there is any clogging, remove the spray arms and clean them under water. You can remove the lower spray arm by pulling it upwards, while the upper spray arm nut can be removed by turning the nut to the left. Be sure that the nut is perfectly tightened when refitting the upper spray arm. Hose filter Water is prevented by the inlet hose filter so as to avoid any damage to your machine because of any contamination (sand, clay, rust etc.) that might be occasionally carried in through the mains water supply or the indoor plumbing, and to forestall such complaints as yellowing and formation of deposits after washing. Check the filter and the hose from time to time and clean them if necessary. To clean the filter, first turn off your tap and then remove the hose. After removing the filter from the hose, clean it under the tap. Insert the cleaned filter back into its place inside the hose. Refit the hose. 24
FAILURE CODES AND WHAT TO DO IN CASE OF FAILURE ERROR CODE ERROR DESCRIPTION CONTROL • Make sure the water input tap is totally open and that there is no water cut. Inadequate water supply • Close the water input tap, separate the water input hose from the tap and clean the filter at the connection end of the hose. • Restart your machine, contact the service if the error resumes. F5 • Close the tap. Error of continuous water input • Contact the service. F3 • Water discharge hose is clogged. • The filters of your machine might be clogged. • Power off-on your machine and activate the program cancellation command. • If the error continues, contact the service. The waste water in the machine cannot be discharged. F2 Heater error 25 Contact the service. F8 • Power off your machine and close the tap. • Contact the service. Alarm is active against water overflow F1 Contact the service. Faulty electronic card FE Contact the service. Overheating error (temperature in the machine is too high) F7 Contact the service. Divisor position error F9 Contact the service. Faulty heater sensor F6
Page 1: Dishwasher Instruction Instruction
Page 4 and 5: Loading your dishwasher .………
Page 6 and 7: GETTING FAMILIAR WITH YOUR MACHINE
Page 8 and 9: Technical specifications Capacity
Page 10 and 11: Recommendations • For energy and
Page 12 and 13: Electrical connection The earthed p
Page 14 and 15: Testing strip The washing effective
Page 16 and 17: Detergent usage Use a detergent spe
Page 18 and 19: Warning: Use only those rinse aid m
Page 20 and 21: Alternative basket loads Lower Bask
Page 22 and 23: PROGRAMME DESCRIPTIONS Programme it
Page 24 and 25: Changing a programme with resetting
Page 28 and 29: If the programme won’t start •
Page 31: THE PRODUCT FICHE (Spect) Supplier'

Dishwasher

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?