LPR-1D - Symeo

LPR ® -1DData SheetLPR® -1DAntennaMeasured DistanceIO boxDistance Measurement, Collision Avoidance,Data Logging and Communication• Wireless measurement via radiowaves• Unaffected by contamination,weather and vibration• For industrial indoor andoutdoor applications• Up to 1800m measurementrange• Simultaneous transfer of userdata• Easy to mount and configure• Maintenance freeLPR®-1D is a wireless distance measurement system based on continuouslycaptured high frequency radio signals. Depending on the application requirements,up to four antennas with different characteristics can be connectedto the unit (see separate LPR® antenna datasheet).In addition to the distance measurement, the LPR®-1D radio link is usedto transfer distance readings between the units as well as other locally captureddata (e.g. hoist height measurement, open/close signals), acquired bya separate IO box.Therefore, all LPR®-1D units in a group share the same data pool and anyunit can be used to interface to that information.Seven optional on-board relays are available to switch dry contacts atfreely determined preset distance values and indicate the units´ power andsignal integrity status.Installation of the antennas does not require precise alignment. Parametersetting can easily be done with the Symeo Wizard PC tool. The Wizardallows to set criteria for switching the relays, set communication addressesand read all captured data.LPR®-1D operates in parallel with WiFi networks and other radio (e.g.voice, remote control) in harsh industrial environments.

Dynamic crane and trolley position measurementwith preset no-go areasTechnical Data: LPR®-1DFrequency rangeOutput power5.725-5.875 GHz, ISM-bandMax. 0.025 W EIRPMeasuring distance Up to 1,800 m *Typical accuracy Up to ± 5 cm *Update rateVoltagePower consumptionUp to 30 Hz10-36 V DC4-8 W at max. update rateAmbient temperature -40 °C to +75 °CProtection classHousing dimensions (LxWxH); weightHardware interfaceData interfaceUser data transfer rateExternal connector typeAntenna(s)Complianceload limit load limitload limit load limitCollision avoidance and applied load limit restrictions forcrane rail sectionsit load limitlimit load limitIP65Data communication and collision avoidance between cranes ondifferent layers260 x 160 x 91 mm; 2.5 kgSerial RS232, TCP/IP (optional), Profibus (optional), 4..20 mA(optional), 7x dry contacts (optional, max. 60 VDC, max. 2 A)Symeo binary protocol, ASCII protocol optional with TCP/IP8 bytes/cycle, up to 240 byte/sConnectors/cable glandsUp to 4 antennas, N-Connector(see antenna catalogue for different types and characteristics)FCC, IC, CETypical applications on cranes, railboundmachines, and generally, measurement of lateralmovement* depending on the type of antenna and application conditionsSYMEO GmbH • Prof.-Messerschmitt-Strasse 3 • D-85579 NeubibergTel.: +49 89 6607796-0 • Fax: +49 89 6607796-190 • www.symeo.com • info@symeo.comVersion 05/2012