ceiling fan must be installed by a licensed electrician - Hunter Pacific

More documents

Recommendations

Info

ElectricianInstallation ManualMajestic Little Bay Ceiling FanIMPORTANT INFORMATIONThe table below contains information that can help you quickly identify the product you areinstalling. If you have any difficulties installing our product, we recommend you to call our warrantyline on 1300 360 280 for advice.CODE SIZEFAN MODEL NAME COLOUR870 107cm, (42”) Majestic Little Bay White871 107cm, (42”)Majestic Little Bay Antique Brass872 107cm, (42”) Majestic Little Bay Brushed Chrome1. Do not attempt to operate the fan (or optional light kit) with any wall control that isnot approved by Hunter Pacific for use with its fans. DO NOT use solid statecontrollers. The use of unapproved controllers will void your warranty.2. Do not mix blade sets from one fan to another as this may upset the balance ofthe fan. If only one blade is damaged you are still required to replace with a new set.4
ElectricianInstallation ManualMajestic Little Bay Ceiling FanInstallation Instructions(Assembling the fan)Ball JointFig. 1Fig. 2CanopyCoverMotor Housing CapBall JointCapFan MotorWiresBall JointCotterWasherConnection CollarCotter KeyCotter PinDownSTEP 2 (Fig. 2)RodScrewa) After the ball joint has been refitted together,feed fan motor wires through the holes on theSTEP 1 (Fig. 1)top of the ball joint cap.b) Push the ball joint cap down to tightly sealONLY PERFORM THIS STEP IF FAN WIRESthe ball joint.HAVE NOT BEEN FED THROUGH DOWN ROD.a) Loosen the ball joint screw and remove theball joint pin to separate the down rod from theball joint.b) Feed wires from motor housing up andthrough the down rod.HangerTimber NoggingBracketc) Insert the cotter pin through the connectioncollar and the down rod (avoid pinching wires).Then lock the down rod using the cotter keyand washer. Secure down rod with the twodown rod screws provided.d) Slide on canopy cover and refit the ball joint.e) If extensions rods need to be installed,please go to page 9.Fig. 3Hex Head Screw.STEP 3 (Fig. 3)a) Drill a hole in timber nogging for wiring. b) Secure the hanger bracket onto the timber nogging,using the two hex head screws provided. The timber nogging should be supplied by the installingelectrician and must be supported between the two ceiling joists as shown in the diagram above.1. Do not attempt to operate the fan (or optional light kit) with any wall control that isnot approved by Hunter Pacific for use with its fans. DO NOT use solid statecontrollers. The use of unapproved controllers will void your warranty.2. Do not mix blade sets from one fan to another as this may upset the balance ofthe fan. If only one blade is damaged you are still required to replace with a new set.5
Page 1 and 2: ElectricianInstallation ManualMajes
Page 3: ElectricianInstallation ManualMajes
Page 11: ElectricianInstallation ManualMajes

ceiling fan must be installed by a licensed electrician - Hunter Pacific

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?