Digest Eng 07-D1 - korloy

KORLOY Chip-BreakersShape Application Range Special FeatureMFFor Finishing of MillingSpecial design for light cutting of gummy materials like stainlesssteel and hard to machine material provide fine surface finishand longer tool life.“SP Drill”Series “Future Mill”SeriesMMMRMADMDSDARecommended Cutting ConditionsV = 150 ~ 300m/min f = 0.05 ~ 0.2mm/tooth500 ~ 990sfm 0.002 ~ 0.008iptFor Medium cutting of MillingChip breaker design to cover general cutting condition providewide available application range.Ground type and as sintered type is available.Recommended Cutting ConditionsV = 150 ~ 250m/min f = 0.05 ~ 0.3mm/tooth500 ~ 825sfm 0.002 ~ 0.012iptFor Roughing of MillingStrongest cutting edge strength provide stable tool life even incase of severe cutting with heavy intermittent and heavyroughing.Recommended Cutting ConditionsV = 150 ~ 250m/min f = 0.05 ~ 0.35mm/tooth500~ 825sfm 0.002 ~ 0.014iptFor Aluminum MillingSuitable design for aluminum machining like sharp cutting edge,mirror face of insert top which prevent build up edge, provideexcellent cutting performance.Recommended Cutting ConditionsV = 300 ~ 1000m/min f = 0.1 ~ 0.35mm/tooth990 ~ 3300sfm 0.004 ~ 0.014iptFor Medium cutting of Drilling.General application of steel, stainless and cast ironStrong cutting edge suitable for interrupted hole drilling.Recommended Cutting ConditionsV=70~170m/min f=0.04~0.12mm/rev230~560sfm0.0016~0.0048iprFor Stainless Steel DrillingAs an insert for stainless steel drilling, combination of high rakeangle and convex dot put on top face make good chip controland long last tool life at the same time.Recommended Cutting ConditionsV=50~120m/min f=0.04~0.15mm/rev160~400sfm0.0016~0.006iprFor Aluminum DrillingAs an insert for aluminum drilling, it has sharp cutting edge andpolished mirror top face. It prevents build-up edge, thus getgreat chip flow.Recommended Cutting ConditionsV=150~300m/min f=0.04~0.16mm/rev500~1000sfm0.0016~0.006ipr15