SECURA KEY CARD ACCESS CONFIGURATION GUIDE Single ...

More documents

Recommendations

Info

¿¿MULTI LOCATION SYSTEM WITH SK-NET-MLD SOFTWARESK-ACP1Up to 100SK-ACP’sSK-ACP¿SK-ACP1¿NET-CONV-PSK-NET TMSOFTWAREMODEMTELCO LINESK-MDMRS-232GATEWAY¿SK-ACP2 1A virtually unlimited number of remote locationscan be set-up on one PC with SK-Net-MLD Software.¿¿SK-ACPSK-ACPUp to 100SK-ACP’s¿NETWORK WIRING CONNECTIONSSK-ACP¿¿Line ALine BMULTI-PANEL SYSTEM USING SK-NET TM SOFTWARE- SINGLE LOCATION RS-485 with CONVERTERSK-NET TMSOFTWARE¿2NET-CONV-PRS232-RS485CONVERTER¿11SK-ACP SK-ACP SK-ACPSK-ACP12NETWORK CABLE:RS-485 communications. Suggested cable: CAT 5network cable or Two Twisted Pair. Total system cablelength: 4,000 ft.SERIAL CABLE:RS-232 communications. Suggested cable: 6-Conductor,Shielded, with no twisted pairs. PC or serial printer. Totalcable length 100 feet. NOTE: Same wire to be used forconnection from SK-ACP to reader. Total cable length500 feet.¿SERIAL PRINTERMONITORS ALL SYSTEM ACTIVITYNote: When using the RS-232 to RS-485 converter, you cannotuse the stubbed, star fanout or “T” configuration. All networkconnections from SK-ACP to the next SK-ACP must be in parallelwith each other. The J8 connector, Pins 1 and 2 must be a twistedpair. Pin 3 (Ground) is NOT normally connected, but if required canuse 1 conductor of a second pair.2
MULTI-PANEL SYSTEM USING SK-NET TM SOFTWARE- SINGLE LOCATION WITH SK-LANNOTE: SK-NET-MLD software must be used when connecting the SK-LAN External Device Server.SK-NET TMSOFTWARE¿3SK-LAN EXTERNALDEVICE SERVER¿2DAISY CHAIN / MULTIDROPSK-ACPSK-ACP1SK-ACPSTAR /FANOUTSK-ACPSK-ACP“T”CONFIGSK-ACP¿SK-ACP SK-ACPSK-ACP1SK-ACP123NETWORK CABLE:RS-485 communications. Suggested cable: CAT 5network cable or Two Twisted Pair. Total system cablelength: 4,000 ft.SERIAL CABLE:RS-232 communications. Suggested cable: 6-Conductor,Shielded, with no twisted pairs. PC or serial printer. Totalcable length 100 feet. NOTE: Same wire to be used forconnection from SK-ACP to reader. Total cable length500 feet.ETHERNET CABLE:Standard ethernet cable connector connected to existingLAN.SK-ACPSTUBBEDNOTE: Each SK-ACP above can support 2 Wiegand output card readers.¿2SERIAL PRINTERMONITORS ALL SYSTEMACTIVITY
Page 1: SECURA KEY CARD ACCESS CONFIGURATIO

SECURA KEY CARD ACCESS CONFIGURATION GUIDE Single ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?