magnetic stirrers MCS66/MCS67 - FineMech

11.5 Writing parameters to the ControllerIf, for example: the motor speed of the motor should be 1000 rpm the max hotplate temperature should be 150 °C, and the probe temperature (ext. PT100 probe) should be 100 °Cthe following command string has to be sent to the controller with slave-address 1:1,WSE,1000,150,100The Controller then sends the following two strings to the next Controller (or back to the PC):1,WSE,1000,150,1001,HS,OKThe first string is the Echo of the received command.The second string indicates that the command was accepted and will be executed.11.6 Reading parameters from the ControllerTo readout the actual stirring speed send the following command to the Controller with SlaveAdress 1.1,RSE,1The MCS66/67 then sends the following two strings to the next Controller (or to back the PC):1,RSE,11,HS,OK,1000,150,100The first string is the Echo of the received command.The second string indicates that the command was accepted and will be executed it also contains thefollowing information (see table 2): the programmed motor speed is equal to 1500 rpm the programmed hotplate temperature is equal to 150°C the programmed probe temperature is equal to 100°Cversion 1.04 page: 25