Fan Circulated Oven 200FD - C R Clarke

200FD Inst Issue 2 06.09.20063. Oven Operation230V MachinesWhen the oven is plugged into its mains supply the green "mains available" indicator lightwill illuminate. Switch on the oven at the mains switch on the control panel (0=off /I=on).this switch incorporates a no-volt release, cutting power to the oven until manually reset inthe event of a power failure.115V MachinesPlug the machine into a suitable mains supply. Switch on at the rotary mains switch (0=off,I=on) and the clear neon will illuminate. Switch on the heater at the main circuit breaker.Set the temperature as follows:200Lift the lower grey cover on the temperature controller and the rotating dial. The settemperature is marked by the arrow at the top of the dial. The controller has threeindicating neons, to show the actual oven temperature in relation to the set temperature,the left hand arrow shows that the oven is below temperature, the right hand arrowshows the oven in above temperature, with the central arrow illuminating when the ovenis at set temperature. There is also a neon in the top left hand corner of the controller, thisilluminates when power is being supplied to the heating element.200FDOven temperature can be adjusted from 0 - 400°C (32 - 750°F). The set temperature can beobserved by momentarily pressing the left button marked * on the controller. To adjustpress and hold the button * and adjust using the ⇓ or ⇑ buttons. The readout will displayactual oven temperature other than when ] is pressed when the target or set point will bedisplayed.HeatingItems can be heated by placing them on or hanging them from the two mesh shelvesprovided. Do not use place items on the mesh heater guard; it is too close to the elementto afford uniform heat distribution.When heating thermoplastic sheets such as acrylic for dome blowing, an aluminium sheetplaced on the shelf will ensure that no marks are left on the material by the bars of theshelves.Leave the oven door closed at all times except when loading and unloading, this ensuresmaximum safety and oven efficiency. When opening the door while the oven is hot, standwell away to avoid the initial "blast" of hot air rising from the interior.When running at temperatures above 300°C (572°F), the oven casing around the upper dooropening may exceed 60°C (140°F).Hazardous materials with a low flash point such as resins, paints, petroleum basedadhesives, low temperature alloys producing toxic fumes etc. should not be putin the oven under any circumstances. If in doubt consult material manufacturers.NO ASBESTOS HAS BEEN USED IN THE MANUFACTURE OF THIS OVEN4