Underdash

More documents

Recommendations

Info

Note:Air ConditionerMACK MS 200 / 250 / 300Model R-2110INSTALLATION INSTRUCTIONSPlease read instructions all the way through and review layout of components illustrated in Fig. 1 beforebeginning work.A. PREPARATION OF TRUCK FOR INSTALLATION OF AIR CONDITIONER UNIT.1. Disconnect batteries.2. Remove glove compartment and center dash panel. (Save parts and screws). See Figure 2.3. Disconnect flex hose from right side of heater unit and move it out of the way.4. Remove tool compartment door by drilling out (4) rivets (discard door). See Figure 2.5. Remove bracket located on tool compartment floor (1987-on model vehicles). Cut holes in toolcompartment floor using template provided. On newer trucks a cut out will already be in the desiredlocations.Red Dot Corporation P.O. Box 88790, Seattle, WA 98138 (425) 251-6897 Fax (425) 251-3934RD-5-5673-0 REV B For Reference Only. Subject to change without notice Page 1 of 8
Red Dot Corporation P.O. Box 88790, Seattle, WA 98138 (425) 251-6897 Fax (425) 251-3934RD-5-5673-0 REV B For Reference Only. Subject to change without notice Page 2 of 8
Page 1 and 2: HEAVY DUTYHEATING & AIR CONDITIONIN
Page 3: RED DOT UNITSR-8725 SYSTEM ORDERING
Page 6 and 7: 1991 AND UP FORD "L" SERIES UNDERHO
Page 8 and 9: RED DOT UNITSHEATER-A/CMACKR-2110 U
Page 12 and 13: Caution: Be careful not to drill in
Page 14 and 15: B. AIR CONDITIONER UNIT INSTALLATIO
Page 16 and 17: D. FINAL ASSEMBLY AND CHECK.1. Rein
Page 18 and 19: RED DOT UNITSHEATER-A/CMACKR-8820 U
Page 20 and 21: Heater - Air ConditionerModel R-882
Page 22: RD-3-8266-0 (REV --)HEATERS ANDAIR
Page 43: RED DOT UNITSINTERNATIONALR-8235 UN

Underdash

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?