Underdash

C. ROUTE AND ATTACH WIRES FROM COMPONENTS AS FOLLOWS.1. Connect 12” red and black wires from power panel to red and black wires from A/C unit.2. Connect black and blue wires from power panel to black and blue wires from condenser fan motor.3. Connect purple wire and black and white wire from A/C unit to orange wire and black and white wire fromtrinary.4. Connect yellow wire from power panel to yellow wire from trinary.5. Connect 4' orange wire from power panel to terminal on back of water temperature gauge.6. 1989-1/2 and newer vehicles.a. Connect 4' red and black wires to power supply connector on blue striped wire. The power supplywire is located behind center dash panel in or near access boot on drivers side of vehicle similar toboot included in this kit.7. 1989 and older vehicles.a. Remove plastic connector from terminals on 4' red and black wires. Plug red wire into blue stripedwire located behind center dash panel on drivers side of heater. Wrap connection with electrical tape.Cut terminal off black wire and install ring terminal included in kit. Attach to suitable ground.8. Use long tie wrap to seal boot around hoses and wires.Red Dot Corporation P.O. Box 88790, Seattle, WA 98138 (425) 251-6897 Fax (425) 251-3934RD-5-5673-0 REV B For Reference Only. Subject to change without notice Page 6 of 8