TMW-128 Decal Placement Guide - Taylor Machine Works
TMW-128 Decal Placement Guide - Taylor Machine Works
TMW-128 Decal Placement Guide - Taylor Machine Works
- No tags were found...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Decal</strong> <strong>Placement</strong> <strong>Guide</strong><strong>TMW</strong>–<strong>128</strong>
RECOMMENDED WARNING DECAL PLACEMENT ON TAYLOR MACHINES PLACEMENT OF DECALS 3377-010, 3377–019, AND 3377–020 ON THE EXTERIOR OF MACHINE... EXAMPLE A ANDEXAMPLE B. PLACE DECAL NO. 3377-010 AS CLOSE AS POSSIBLE TO DECAL NO. 3377-020 AND IN CLEAR VIEW OF THEOPERATOR AND BYSTANDERS. PLACE DECAL NO. 3377–019 CENTERED ON ACCESS STEPS AND CLEARLY VISIBLE AS INDICATED IN EXAMPLE A.AND EXAMPLE B.DECAL NO. 3377-010 DECAL NO. 3377-019 DECAL NO. 3377-020SERIOUS FALLS OR INJURIES CAN RESULTFROM IMPROPERLY MOUNTING OR DISMOUNTINGPOWERED INDUSTRIAL TRUCKS.OPERATORSFace truck when getting on or off truck.One hand and two feet or two hands and onefoot must be in contact with the truck at alltimes. (3 point contact)Use handrails and other grab points.Never climb on truck areas not meant foroperator travel.MAINTENANCE PERSONNELKeep truck clean, free of oil, grease,and fuel.Steam clean / wash truck and wear anti-slipfootwear prior to performing maintenance.Use OSHA approved ladders and other propercleaning accessories to access hard toreach maintenance areas.Keep grating free of ice, dirt, and gravel.Regularly inspect and replace anti-slipmastic as needed.Ensure safety decals are in place. 650 NORTH CHURCH AVENUELOUISVILLE, MISSISSIPPI 39339–2017 3377 010DEATH or SERIOUS INJURY mayresult from allowing riderson this machine.NO RIDERS.3377 019DEATH OR SERIOUS INJURY MAY RESULT FROMIMPROPER OPERATION OF THIS MACHINE.Operator must be trained and knowledgeable ofthe operators guide, safety manual, and OSHASTANDARD 29 CFR, 1910.178 for poweredindustrial trucks.Capacity is with mast in vertical position andload retracted.Capacity greatly decreases with tilting, highload lifting, acceleration, braking, sharpturning, high wind velocity, and poor yardconditions.Tilt (mast and load out) only when load is overa stack.Visibility may be impaired by structuraldesign (ALWAYS look in the direction of travel;DO NOT rely on mirrors.)Do not operate with bystanders present.Always travel with load in lowest possibleposition that allows good visibility.Always wear seat belt while machine is inoperation.Do not attempt to jump from machine in event oftip over. Remain seated with seat belt fastened. 650 NORTH CHURCH AVENUELOUISVILLE, MISSISSIPPI 39339–2017 3377 020WARNING / DEATH OR INJURYDECAL PART NO. 3377-020WARNING / DEATH OR INJURYDECAL PART NO. 3377-020MAINTENANCE DECALDECAL NO. 3377-010MAINTENANCE DECALDECAL NO. 3377-010-EXAMPLE A-NO RIDERS DECALDECAL NO. 3377-019NO RIDERS DECALDECAL NO. 3377-019WARNING / DEATH OR INJURYDECAL PART NO. 3377-020NO RIDERS DECALDECAL NO. 3377-019NO RIDERS DECALDECAL NO. 3377-019WARNING / DEATH OR INJURYDECAL PART NO. 3377-020MAINTENANCE DECALDECAL NO. 3377-010-EXAMPLE B-MAINTENANCE DECALDECAL NO. 3377-010PLACEMENT OF DECALS MAY VARY DUE TO CONSTRUCTION DESIGN OF MACHINES.DECALS SHOULD ALWAYS BE PLACED ON SURFACES THAT ARE HIGHLY VISIBLE TO THE OPERATORAND BYSTANDERS.1<strong>TMW</strong>-<strong>128</strong> (01/28/13)
Warning <strong>Decal</strong> No. 3377–024 advises personnel to stay clear of the front–end lifting mechanisms on <strong>Taylor</strong> machines.The decal should be placed as close as possible to eye level on both sides of the mast as shown below.For additional information or instruction contact the Customer Assurance Division at <strong>Taylor</strong> <strong>Machine</strong> <strong>Works</strong>.WARNING DECAL NO. 3377-024DEATH or SERIOUS INJURY mayresult from improper operationof this machine.STAY CLEAR3377 024WARNING DECALPART NO. 3377-024WARNING DECALPART NO. 3377-024WARNING DECALPART NO. 3377-024WARNING DECALPART NO. 3377-0242<strong>TMW</strong>-<strong>128</strong> (01/28/13)
<strong>Decal</strong> No. 3377-106DANGERVehicle makes wide turnsSTAY CLEAR<strong>Placement</strong> of <strong>Decal</strong> No. 3377-106 on exterior of machine... Example ADANGER / WIDE TURNDECAL PART NO. 3377-106DANGER / WIDE TURNDECAL PART NO. 3377-106Example A<strong>Placement</strong> of <strong>Decal</strong> No. 3377-106 on exterior of machine... Example BDANGER / WIDE TURNDECAL PART NO. 3377-106DANGER / WIDE TURNDECAL PART NO. 3377-106Example B3<strong>TMW</strong>-<strong>128</strong> (01/28/13)
<strong>Decal</strong> No. 3377-134 <strong>Decal</strong> No. 3377-022DEATH OR SERIOUS INJURY MAY RESULT FROMIMPROPER OPERATION OF THIS MACHINE.Operator must be trained and knowledgeable ofthe Operators <strong>Guide</strong>, Safety Manual, and OSHAStandard Section 1910-178 for Powered IndustrialTrucks.Capacity is with mast in vertical position andload retracted.Capacity greatly decreases with tilting, highload lifting, acceleration, braking, sharpturning, high wind velocity, and poor yardconditions.Tilt (mast and load out) only when load is overa stack.Visibility may be impaired by structural design.(ALWAYS look in the direction of travel; do not relyon mirrors.)Do not operate with bystanders present.Always travel with load in lowest possibleposition that allows good visibility.Always wear seat belt while machine is inoperation.Do not attempt to jump from machine in event oftip over! Remain seated with seat belt fastened.DANGERSTAY CLEAR Highway 15 North/Louisville, Mississippi 393393377 134<strong>Placement</strong> of <strong>Decal</strong> No. 3377-134... Right-hand Side Operator in a location that is easily visible to the operatorat all timesWARNING / DEATH OR INJURYDECAL PART NO. 3377-134TOP VIEW OF SEATDANGER / STAY CLEARDECAL PART NO. 3377-022<strong>Placement</strong> of <strong>Decal</strong> No. 3377-022 should be horizontally centered between the <strong>Taylor</strong> logo and the top of thecounterweight plate (as illustrated) on the rear of the machine.4<strong>TMW</strong>-<strong>128</strong> (01/28/13)
<strong>Decal</strong> No. 3377-025WARNING DECALPART NO. 3377-025Rotating fan cancause severe injury.STAY CLEAR of fanwhile engine isrunning.3377 025SHROUDRADIATORThis decal warns personnel to stay clear of the fan if they are servicing the machine with the engine running.The decal should be placed on top of the fan shroud as shown below. If the fan shroud is too narrow or if the machineis equipped with side doors instead of a top raising hood, a decal should be placed on each side of the enginecompartment in a highly visible location. Apply the decal to a clean, dry, oil free surface. Do not apply thedecal to the rediator because heat will destroy it.IF ANY OF THE FOLLOWING DECALS ARE MISSING FROM YOUR MACHINE IT IS IMPORTANT THATYOU REPLACE THEM IMMEDIATELY.3377-134 OR 3377-001 3377-020, 3377-106,3377-010, 3377-019, 3377-022, 3377-024,3377-025IF YOU NEED ASSISTANCE, CONTACT YOUR LOCAL TAYLOR DEALER OR TAYLOR MACHINE WORKS’MARKET RESEARCH DEPARTMENT AT (662) 773-3421 EXT. 190TAYLOR MACHINE WORKS, INC.650 NORTH CHURCH AVENUELOUISVILLE, MISSISSIPPI 39339-2017PHONE (662) 773-3421FAX 662-773-91835<strong>TMW</strong>-<strong>128</strong> (01/28/13)
Change language