MSDS - DuBois Chemicals Online Store

6.Accidental release measuresLarge spill :7.HandlingStorage8.Handling and storageOccupational exposure limitsNo exposure limit value known.::Stop leak if without risk. Move containers from spill area. Approach release from upwind.Prevent entry into sewers, water courses, basements or confined areas. Wash spillagesinto an effluent treatment plant or proceed as follows. Contain and collect spillage withnon-combustible, absorbent material e.g. sand, earth, vermiculite or diatomaceous earthand place in container for disposal according to local regulations (see section 13).Dispose of via a licensed waste disposal contractor. Contaminated absorbent materialmay pose the same hazard as the spilled product. Note: see section 1 for emergencycontact information and section 13 for waste disposal.Put on appropriate personal protective equipment (see section 8). Eating, drinking andsmoking should be prohibited in areas where this material is handled, stored andprocessed. Workers should wash hands and face before eating, drinking and smoking.Do not ingest. Avoid contact with eyes, skin and clothing. Avoid breathing vapor or mist.Keep in the original container or an approved alternative made from a compatiblematerial, kept tightly closed when not in use. Empty containers retain product residue andcan be hazardous. Do not reuse container.Store in accordance with local regulations. Store in original container protected fromdirect sunlight in a dry, cool and well-ventilated area, away from incompatible materials(see section 10) and food and drink. Keep container tightly closed and sealed until readyfor use. Containers that have been opened must be carefully resealed and kept uprightto prevent leakage. Do not store in unlabeled containers. Use appropriate containmentto avoid environmental contamination.Exposure controls/personal protectionConsult local authorities for acceptable exposure limits.Recommended monitoringproceduresEngineering measuresHygiene measuresPersonal protectionRespiratoryHands :EyesSkin: If this product contains ingredients with exposure limits, personal, workplace atmosphereor biological monitoring may be required to determine the effectiveness of the ventilationor other control measures and/or the necessity to use respiratory protective equipment.: No special ventilation requirements. Good general ventilation should be sufficient tocontrol worker exposure to airborne contaminants. If this product contains ingredientswith exposure limits, use process enclosures, local exhaust ventilation or otherengineering controls to keep worker exposure below any recommended or statutorylimits.: Wash hands, forearms and face thoroughly after handling chemical products, beforeeating, smoking and using the lavatory and at the end of the working period. Appropriatetechniques should be used to remove potentially contaminated clothing. Washcontaminated clothing before reusing. Ensure that eyewash stations and safety showersare close to the workstation location.:::Use a properly fitted, air-purifying or air-fed respirator complying with an approvedstandard if a risk assessment indicates this is necessary. Respirator selection must bebased on known or anticipated exposure levels, the hazards of the product and the safeworking limits of the selected respirator.Chemical-resistant, impervious gloves complying with an approved standard should beworn at all times when handling chemical products if a risk assessment indicates this isnecessary.Recommended: natural rubber (latex)Safety eyewear complying with an approved standard should be used when a riskassessment indicates this is necessary to avoid exposure to liquid splashes, mists ordusts. Recommended: splash gogglesPersonal protective equipment for the body should be selected based on the task beingperformed and the risks involved and should be approved by a specialist before handlingthis product.Validated on 8/16/2010.TREO GENERAL PURPOSE CLEANER3/6