3.0 crypto transponder interface - Xcardiag.com

www.xcardiag.com3.0 CRYPTO TRANSPONDERINTERFACEIf a problem is detected, the red LED will indicate a fault code by blinking. Thewww.xcardiag.comnumber of times the LED blinks denotes what the fault code is, please refer to thechart below:BlinksDescription812345678910Communication errorCheck all connections and make sure devices are onTransponder not foundCheck that the transponder is in the AD90 key readerWrong transponder.Swap it to a PHILIPS PCF 7935 / 79935, 42 IDWrong transponder dataThe transponder seems to be OK but the data does not meetthe Philips 42 standardIncorrect command to the AD90www.xcardiag.comDisconnect and re-connect all devicesWrong AD90 software versionVersion must be 3.14 or higherWrong data sent by AD90Repeat the procedureTime OutYou took to long to press a keyTransponder cannot be decryptedContact your distributorNot enough memoryData too large, use a different transponder and repeatprocedureIncorrect transponder dataThe transponder seems to be OK but the data does not meetthe Philips 42 standard11www.xcardiag.comWrong data sent to AD9012Repeat the procedure1314Communication errorCheck all connections and make sure devices are onCommunication error to AD90Check all connections and make sure devices are onE-mail:sales@xcardiag.com Yahoo:XcarDiag@yahoo.comSkype: XcarDiagMSN:XcarDiag@hotmail.com