Weldmatic 175 [internal wirefeeder] - BJH

More documents

Recommendations

Info

Operators Manual3 SpecificationsManufactured to Australian StandardAS60974.1.Primary Voltage240 Vac, 50/60 HzRated Primary Current12 AmpsMaximum Primary Current28 AmpsRecommended Generator kVA6.7 kVARated Output @ 40 o CDuty cycle based on 10 minute cycle time175 Amp, 22.8 V, 15% duty67 Amp, 18 V, 100% dutyWelding Current35 - 175 AmpsIf the supply cable is damaged it mustbe replaced by the manufacturer, theirservice agent or a similarly qualifiedperson.CoolingFan cooled, air drawn in through rear grille.InsulationClass H, 140°C RiseSpool Sizes1 kg, 5 kgWirespeed Range0 - 160 RPM (0 - 15 Metres per min.)Wire Size Range0.6mm - 0.9mm diameter (solid wire)0.8mm - 1.2mm diameter (cored wire)Open Circuit Voltage19 - 40 VShipping weight45 kgMains Circuit Breaker Rating16 AmpsSupply plug15 AmpFitted Supply Cable30/0.25 Three Core, Heavy Duty PVCQuality • Reliability • Performance
Weldmatic 1754 Controls12345678Fig 1 Power Source Controls1 Wire Speed ControlThis control provides adjustment of thewirefeed speed. Rotating the dial in aclockwise direction will increase the wirefeedspeed, thereby increasing the weldingcurrent.Refer to the Weld Setting Chart in Section7 of this manual for information on settingthese controls to obtain the intendedwelding current. This chart is also locatedinside the wire-spool enclosure cover2 Euro Gun/Cable Connector.3 Coarse Voltage ControlThis switch provides Coarse adjustmentof the output welding voltage over threeranges.4 Over Temprature IndicatorLights up if the unit over heats5 Fine Voltage ControlThis switch provides Fine adjustment of theoutput welding voltage over three ranges.Note: Minimum welding voltage is obtainedwith Coarse A and Fine 1 selected. Maximumwelding voltage is obtained with Coarse Cand Fine 3 selected.Do not operate the Voltage Controlswitches during welding6 Standby/Operate Switch7 Positive Welding Output Terminal8 Negative Welding Output TerminalModel No CP122, Iss A 07/07
Page 5: Weldmatic 175Burn protectionThe wel
Page 10 and 11: Operators Manual5 InstallationConne
Page 12 and 13: Operators Manual6 Normal Welding Se
Page 14 and 15: Operators ManualWeldmatic 175Settin
Page 16 and 17: Operators Manualoperated with appro
Page 18 and 19: Operators Manual9 External Trouble
Page 20 and 21: Operators Manual10 Service Informat
Page 22 and 23: Operators Manual11.1 Assembly and P
Page 24 and 25: Operators Manual11.2 Assembly and P
Page 26 and 27: Operators ManualTipsWire diameter0.
Page 28: Operators Manual(2) replacement; or

Weldmatic 175 [internal wirefeeder] - BJH

Create successful ePaper yourself

Delete template?

Save as template?