TMaxx operating instructions 52 - Great Hobbies

Use theRight ChargerThe most convenienttype of charger is an AC peakdetectingcharger that plugsdirectly into an AC walloutlet. It contains specialpeak-detection circuitry thatautomatically shuts thecharger off when the batteryis fully charged.If you’re using a 15-minutetimed charger, always fullydischarge the battery packbefore each charge. Somehigh mAh battery packs(1500 mAh or higher) requiremore than the standard 15minutes of charge time. If thebattery pack is cold after 15minutes of charging, addanother 5 minutes of chargetime. Closely monitor thebattery pack and stopcharging it when it begins tofeel warm to the touch. Neverleave a battery chargingunattended. Always followcharger manufacturer’sinstructions.The TRX 2.5 Racing EngineThe Traxxas EZ-Start Electric Starting SystemThe Traxxas EZ-Start brings the convenience of push-buttonelectric engine starting to your T-Maxx. The EZ-Start consists of ahandheld control unit and an on-board motorized starter.▼ ▼ ▼ ▼ ▼ ▼ ▼Power for the EZ-Start system comes from a 7.2-voltrechargeable NiCad battery pack installed in the handheldcontrol unit (battery not included).The engine glow plug is heated automatically by theEZ-Start system, eliminating the need to keep up with aseparate glow plug igniter.The voltage to the glow plug is kept constant, regardless ofthe load placed on the starter by the starter motor.The “Glow Plug” LED (light emitting diode) on the controlunit indicates the condition of the glow plug.The “Motor” LED indicates the status of the EZ-Start electricstarter motor.The cush drive mechanism in the drive unit preventsdamage to the gears caused by engine kickback.Smart Start protection circuitry prevents damage to themotor by cutting power if the load on the motor or otherelectronics exceeds safe limits.Installing the EZ-Start BatteryThe EZ-Start system requires a fully charged 7.2-volt NiCadbattery pack (not included). Use a charger (not included)designed for 7.2-volt battery packs. Charge the batteryaccording to the charger manufacturer’s directions.1. Press the tab in the end of the battery compartment doorto open2. Plug a fully charged 7.2-volt NiCad battery pack into theconnector inside.3. Twist the battery 2 or 3 times to twirl the battery plug wires.This helps hold the wire and battery in place when thebattery is placed in the compartment4. Place the battery into the compartment and press the wiressecurely into place.5. Slide the battery compartment door back on and lock theend tab.30