Technical Manual - Carpat Energy

More documents

Recommendations

Info

Wiring with Digital OutputsThe following is a wiring example with relay output.
General Device SettingsModes of OperationThe current RWR470.10 controller consists of three kinds of operation modes:ModeFunction1 Normal working mode Display all running devices and measured values2 Menu mode* View configured analog inputs, warning and alarm logsSet/adjust parameter values and also user privilege toparameters3 Stop mode** Normally shut‐down status (all units stop running.)*To enter menu mode, see also .• In normal working mode, the back light will be timed out after 30seconds without any operation.Accessing the MenusDisplay.+-ProceduresIn Stop mode, press the buttonfor 2 seconds and release it to enter theMenu mode.By default, the Query icon is blinking,waiting for further instructions.To view the latest 10 warnings generated:• Navigate to the menu by pressing or , and then press to confirm and proceed.To view the latest 20 alarms generated:• Navigate to the menu by pressing or , and then press to confirm and proceed.To set parameter values:• Navigate to the menu by pressing or , and then press to confirm and proceed. Contents under this menu may vary with the privilege rightof the user.− For end users, select “NO,” and press to proceed.− For service men and factory users, select “EU” or ”ID” and press toinput the password.
Page 1 and 2: jolietenergies renouvelablesTechnic
Page 3 and 4: Hydraulic configurationsUsing a hea
Page 5 and 6: Using a heat pump for heating and d
Page 7 and 8: Pipework installation must be carri
Page 9 and 10: Outside temperature sensorThe outsi
Page 11 and 12: OperationLCD DisplayOperation of RW
Page 13 and 14: Menu TreeNoteBy default, end users
Page 15: Wiring with Power SupplyRWR470.10 i
Page 19 and 20: Changing Set points (for end users)
Page 21 and 22: Adjusting Parameter ValuesProcedure
Page 23 and 24: Auto Reset AlarmsThe following are
Page 25 and 26: Main Control LogicCompressor Capaci
Page 27 and 28: 9.6.3 TURN ON process at HOT WATERW
Page 29 and 30: Parameter TablesCompressor Settings
Page 31 and 32: User SettingsParameterST01 Setpoint
Page 33 and 34: Heating compensation curve(SF04=1)T
Page 35 and 36: Heat pump dimensionsGeopac GSWW20/2
Page 37 and 38: Geopac heat pump range specificatio

Technical Manual - Carpat Energy

Create successful ePaper yourself

Delete template?

Save as template?