Series J Shaft Mounted Gearbox - Benzlers

SERIES JDIMENSIONS - DOUBLE REDUCTIONKIBOJ100 - 190 Double ReductionPlease note: Dimensions R, T, T1, T2, T3are not machined, deviations can occur.LSize Ratio A AC C 1 RP J KM N P R T T1 T2 T3 S 2 U V Wmax minJ100 15/20/25:1 274 22 154.5 14.5 99 180 755 500 30 30 83 170 98 131 197 230 224 436 211 238J110 15/20/25:1 312 24 170 30 121 197 730 490 35 36 75 228 112 147 213 248 250 496 253 284J125 15/20/25:1 355 26 181.5 11.5 142 214 730 490 35 36 78 246 133.5 168.5 242.5 277.5 280 534 261 319J140 15/20/25:1 375 29 197 28 125 262 715 495 40 42 114 257 138,5 183,5 265,5 310,5 315 630 308 340J160 15/20/25:1 408 30 232.5 32.5 137 297 715 495 40 42 85 290 149 194 274 319 355 712 331 390J190 15/20/25:1 439 36 208 8 170 332 914 625 50 48 102 315 170.5 220.5 300.5 350.5 400 824 403 453Size Ratio X Y ZInput shaft Shaft sleeve 5 WeightkgF 6 H 7 G FA D 3,8 B 4 EJ100 15/20/25:1 584 337 94 55 16 59 M20 100 28 106.4 238J110 15/20/25:1 704 405 112 55 16 59 M20 110 28 116.4 335J125 15/20/25:1 768 461 126 60 18 64 M20 125 32 132.4 416J140 15/20/25:1 830 465 88 70 20 74.5 M20 140 36 148.4 587J160 15/20/25:1 933 527 87 80 22 85 M20 160 40 169.4 796J190 15/20/25:1 1103 623 136 90 25 95 M20 190 45 204.4 1081notes1. The V-belt pulley should be placed as close to thehousing as possible.2. These dimensions are minimum diameters of drivenpulley to prevent overloading of the bearings.3. Tolerances according to ISO H7.4. Tolerances according to ISO E9.5. The reducer should normally be mounted on a shaftwith tolerance ISO js6. On heavy duty applicationscloser tolerances are recommended.6. Tolerances according to ISO m6.7. Tolerances according to ISO h9.8. Space for spacer if locking ring is used.20