Open Season™ Conversion Kit - Raw Thrills, Inc.

Service ManualTroubleshootingMessage Possible Cause SolutionGuns won’t register, or function Bad calibrationCalibrate guns.poorlyDirty/damaged lensClean gun lens.Bad I/O boardMark, should they replace it?Gun disconnectedCheck connections.Monitor glass dirtyClean glass according to instructionsin original game.Display out of adjustmentEnter display diagnostics menu andrepair.Game resets Missing or corrupt files Run File Test.Recover hard drive.Faulty hard drive or RAMReplace and recover hard drive. Seeprocedure at end of this chapter.Replace RAM chips.Coin meter does not click duringTestNo pulse to meterFaulty meterCheck all wiring from meter to I/OboardReplace coin meterExits Test Mode every 3 seconds Test button stuck in ON position Slide or toggle button off after TestMenu appearsNo Signal Video cable not secure. Check and secure video connector.PC not turned on.Sync Polarity incorrect.Turn PC power switch on. EnsureIEC cable tightly plugged in. Tracecable to source to ensure continuity.Change DIP switch settings forHSYNC and VSYNC.Dongle Not Present Dongle missing or disconnected Find dongle and reseat in USB portFaulty USB portInsert dongle in different USB portConnect I/O Board orI/O Board MissingWatchdog Disabled orWatchdog FailedUSB cable disconnectedNo power to JAMMA I/O boardI/O board faultyWatchdog defeated by JAMMA I/ODIP switchNo power to Reset PCBReset input to motherboarddisconnectedViolet or black wire from Reset PCBdisconnected or faultyCheck USB connection from PC toI/O boardCheck for proper voltage (+5V,+12V) at JAMMA connectorReplace boardSet DIP switch 8 to OFFConnect power to Reset PCBConnect 2-pin reset connector fromReset PCB to motherboard reset pininputCheck reset wire connection toJAMMA connector.Big Buck Hunter® Pro Open Season is a trademark of Play Mechanix Inc. All rights reserved. Page 44