Control Valve Drive Parts List - Clean My Water

Turning the Water Back OnPage 131. INSTRUCTIONS FOR USING A BYPASS VALVE. If you are using a bypass valve,make sure your bypass valve is now in the "BYPASS" position.2. Turn your water on slowly, leaving all your faucets in the house open until waterstarts coming out of them. After they are all running steady and the air is out of thewater lines, turn them off one by one. The raw water will be bypassing your system atthis time.3. Slowly open your bypass valve to the “SERVICE” position and begin filling the softenerresin tank with water. In a few minutes the sound of water entering the systemwill stop.4. Next, open one faucet, (preferably an outside faucet, a laundry sink or bathtub), lettingthe water run through it slowly for a few minutes. This allows the water to rinsethe inside of your resin tank out and settle the media.5. Sometimes you may experience some light/medium brown color rinsing off the newresin beads..... This is normal...and should only last a few minutes.6. This is why we suggest running the water through only one faucet, to clear the softenerof this colored water.7. After a few minutes, and the water is running clear.....turn the faucet off.8. You now have soft water on your cold water side.... The hot water will take a coupleof days to become soft, as your hot water tank is full of hard water.9. Finally, if you are using a demand valve firmly insert the small brass end of the blackMeter Cable, into the small hole located on top of the dome shaped Meter housing.The end of the cable will only insert about 1/8" - 3/16" into the meter housing hole.Tech Support: 1-888-989-7873PURE WATER TREATMENT, INC.