User Manual - Infosec

4.2 Equipment Reception.4.2.1 Unpacking and content checking.On receiving the device, make sure that it has not suffered any damage during transportation. Otherwise,make all pertinent claims to your supplier or to our company. Also check that the data on the nameplate,which is affixed inside the front door (PF), corresponds to those specified in the purchase order, to do this,you will need to unpack it. In the event of non-conformity please give notification as soon as possiblequoting the device serial number and references of the delivery remittance.When the device has been accepted, it is best to repack the UPS until it is commissioned in order to protectit from any knocks, dust, dirt, etc....The packaging of the device consists of a wooden pallet, a cardboard or wooden surround depending onthe case, expanded polystyrene corner pieces, polyethylene sleeve and band, all recyclable materials; theyshould therefore be disposed of according to current regulations. We recommend that the packaging is keptfor future use.To unpack, cut the bands on the cardboard surround and remove it from above as if it is an cover orremove it with the necessary tools if the surround is made of wood; remove the corner pieces and theplastic sleeve. The UPS will be unpacked on the pallet, to lower it suitable equipment must be used with therequired safety equipment (use plank to remove UPS from pallet). The approximate weights of table 7 and8 must be considered.Fig.11. Front view UPS locationFig.12. Top view UPS location.4.2.2 Storage.The UPS will be stored in a dry, well-ventilated place and protected against rain, water jets or chemicalagents. It is advisable to keep the equipment and the battery pack(s) in their original package which hasbeen designed to assure maximum protection during transport and storage. Except special cases the UPS has sealed airtight, lead batteries and should not be stored for more than 12months (see the date the batteries were last charged on the label affixed to the device packaging or on thebattery cabinet).After this time, connect the device to the mains along with the battery pack(s), as the case may be. Start itup as per the instructions given in this manual and charge the batteries for 12 hours from float level.16INFOSEC UPS SYSTEM - 4, rue de la Rigotière - 44700 Orvault - FRANCE - www.infosec-ups.comHot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 06 11 AA 59 201 02