Tank Drawdown Installation Instruction Manual - Franklin Electric

More documents

Recommendations

Info

TANK DRAWDOWNINSTALLATION INSTRUCTION MANUAL8. Connect the black wire from the cut-in pressure switch to the Normally Closed(NC) terminal on the Auxiliary Relay Board. Connect the Red wire from theregulating pressure switch to the Normally Open (NO) terminal on the AuxiliaryRelay Board.9. Connect the orange and blue wires to the shut-off terminals.8
TANK DRAWDOWNINSTALLATION INSTRUCTION MANUAL10. Re-attach the access cover.11. Re-apply power.12. Adjust the pressure setting on the low pressure cut-in switch for theappropriate off time. The pressure setting on the additional sensor will need to beset below the regulating sensor, but above the tank pre-charge pressure.9
Page 1 and 2: SubDriveTank Drawdown InstallationI
Page 3 and 4: TANK DRAWDOWNINSTALLATION INSTRUCTI
Page 11: TANK DRAWDOWNINSTALLATION INSTRUCTI

Tank Drawdown Installation Instruction Manual - Franklin Electric

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?