Metal working machines - Stuermer Maschinen

BF 30Vario / F 40 ECNC complete add-on kitZ axisZ axisTorque 11.6 Nmon the spindle Z axisTravel speed*· max. 14 mm/sec. with trapezoid spindle· max. 18 mm/sec. with ball screwY axisTorque 11.6 Nmon the spindle X- and Y axisTravel speed*· max. 16 mm/sec. with trapezoid spindle· max. 20 mm/sec. with ball screwX axisDescription „BF 30Vario“ on page 123CNC complete add-on kit*Consisting of:· 1 x CNC Controller IV· 3 x CNC control cards· 1 x reference switch kit milling· 1 x CNC add-on kit MK F30DPScope of delivery: Add-on kit MK F30DP· 3 x step motors 8 Nm· 3 x assembly housing incl. lid· 3 x toothed belts· 6 x toothed belt pulleys· 1 x distance ring· 2 x nuts· 1 x bushing· 15 meters shielded cable· Set of screwsAdd-on kit without workshop assembly 357 0034 2'590.001Add-on kit with workshop assembly* 353 9023 2'890.00Complete kit ball screws Item No € plus VATfor BF 30 Vario (not possible for F 40 E)Consisting of:· 3 x ball screws with spindle nut· Ball screws for three axesWithout workshop assembly 357 4455 850.00With workshop assembly 353 9223 1'490.00Ball screws individualfor BF 30 Vario (not possible for F 40 E)· with spindle nutX axis Ø 20 mm 357 4311 299.00Y axis Ø 20 mm 357 4312 289.00Z axis Ø 25 mm 357 4313 289.00Factory assembly ball screw 900 0523 249.00· Each axisTransportation packaging flat rate€ 59.00 (TPFR 3) plus VATfor workshop assembly*Important notes:· The indicated speeds represent a nominal value which was determined on the current BF30 Vario .They can deviate up and down depending on the used software system and on the operating moderesp. the load of the motor.· The indicated travels can change when using ball screws.· The EU Directive EN2006/42 EC is complied with only with the housing SHC, the electronic kit and aworkshop assembly in an authorised workshop.· Without the SHC and the safety kit the machine is incomplete in the CNC equipment, thus the CE directiveis not complied with.· We imperatively recommend the briefing performed by our specialists.Software recommendations onpage 222210