BES Ap<strong>pro</strong>ved Label 1106 Solfac Pro Residual Insecticide Page 2 of 7MAIN PANEL – 200 mLCAUTIONKEEP OUT OF REACH OF CHILDRENREAD SAFETY DIRECTIONS BEFORE OPENING OR USINGSolfac ® ProRESIDUAL INSECTICIDEACTIVE CONSTITUENT: 25 g/L BETACYFLUTHRINContents200 mLGROUP 3AINSECTICIDEFor the control of cockroaches, spiders, ants, fleas, flies, silverfish, bedbugs,millipedes, mosquitoes, crickets, stored <strong>pro</strong>duct pests, armyworm, cutworm,webworm, adult scarabs, sawfly larvae and ornamental pests in thesituations specified in the directions for use.IMPORTANT: Read the attached booklet before use.APVMA Ap<strong>pro</strong>val Number: 59424/200/0906
BES Ap<strong>pro</strong>ved Label 1106 Solfac Pro Residual Insecticide Page 3 of 7Front page of booklet – all packsCAUTIONKEEP OUT REACH OF CHILDRENREAD SAFETY DIRECTIONS BEFORE OPENING OR USINGSOLFAC PRO RESIDUAL INSECTICIDEACTIVE CONSTITUENT: 25 g/L BETACYFLUTHRINGROUP 3A INSECTICIDEFor the control of cockroaches, spiders, ants, fleas, flies, silverfish, bedbugs, mosquitoes, crickets, stored<strong>pro</strong>duct pests, armyworm, cutworm, webworm, adult scarabs and sawfly larvae in the situations specified inthe directions for use.STORAGE AND DISPOSAL: Store in the closed, original container in a cool, well-ventilated area. Do notstore for <strong>pro</strong>longed periods in direct sunlight.Rinse containers before disposal. Add rinsings to spray tank. DO NOT dispose of undiluted chemicals on site.Dispose of at a local <strong>au</strong>thority landfill. If no landfill is available, bury the containers below 500 mm in a disposalpit specifically marked and set up for this purpose clear of waterways, desirable vegetation and tree roots.Empty containers and <strong>pro</strong>duct should not be burnt.SAFETY DIRECTIONSWhen using the prepared spray by hand-held equipment wear cotton overalls, over normal clothing,buttoned to the neck and wrist and a washable hat and elbow length PVC gloves. After each days use washgloves and contaminated clothing.RE-ENTRYDo not enter treated areas until the spray has dried.FIRST AIDIf poisoning occurs contact a doctor or Poisons Information Centre (Phone Australia 131126). Remove fromcontaminated area. Apply artificial respiration if not breathing.MATERIAL SAFETY DATA SHEETAdditional Information is listed in the Material Safety Data Sheet.Exclusion of LiabilityThis <strong>pro</strong>duct must be used strictly as directed, and in accordance with all instructions appearing on the labeland in other reference material. So far as it is lawfully able to do so, Bayer CropScience Pty Ltd accepts noliability or responsibility for loss or damage arising from failure to follow such directions and instructions.SOLFAC ® is a registered trademark of Bayer.Bayer Environmental ScienceA Business Group of Bayer CropScience Pty LtdA.B.N. 87 000 226 022391-393 Tooronga RdEast Hawthorn, Vic. 3123Phone: (03) 9248 6888Fax: (03) 9248 6800Website: www.bayercropscience.<strong>com</strong>.<strong>au</strong>Batch Number:DOM:For 24 hour specialist advice in an emergency only phone 1800 033 111