1756HP-CNV USER MANUAL - Hiprom

More documents

Recommendations

Info

1756HP-CNV - User Manual Rev 1.1CHAPTER 4INSTALLING THE MODULEThe module is equipped with a RIUP (Removal and Insertion Under Power) circuitryenabling the module to be installed or removed from the chassis while power is applied.Attach the cable to the module via the RJ45 connector. Connect the communication wiresBlue (A), White/Blue (B), Brown (Ground) to the correct bus terminals of the 4-wirecommunications bus that runs to the slaves.Once the module powers up, it will immediately look at the parameters defined and startsearching for the KeyID slaves as set out in the parameters.Page 6 of 17.
1756HP-CNV - User Manual Rev 1.1CHAPTER 5CONFIGURING THE MODULE5.1. Establishing the Direct ConnectionThis section describes the procedures necessary to configure the 1756HP-KeyID modulewithin the ControlLogix system. Each 1756HP-KeyID module must be owned by a singleControlLogix controller.The 1756 Generic Module is used in RSLogix5000 to configure the module. Theconfiguration of the module is detailed in the table below.Data FormatCommFormatData – INTConnection parametersDescription Instance SizeInput 1 192Output 2 38Configuration 4 0RPIMin 5 msec Max 750.0 msecTable 5.1 : 1756HP-KeyID connection parameters.The steps required to add a new 1756HP-KeyID module are detailed below.Figure 5.1 : Right-click on I/O Configuration and select New ModulePage 7 of 17.
Page 1 and 2: 1756HP-CNVUSER MANUALRev 1.1 - Dece
Page 3 and 4: 1756HP-CNV - User Manual Rev 1.1CHA
Page 5: 1756HP-CNV - User Manual Rev 1.1CHA
Page 9 and 10: 1756HP-CNV - User Manual Rev 1.1Fig
Page 11 and 12: 1756HP-CNV - User Manual Rev 1.1Int
Page 13 and 14: 1756HP-CNV - User Manual Rev 1.1APP
Page 15 and 16: 1756HP-CNV - User Manual Rev 1.1Nex
Page 17: 1756HP-CNV - User Manual Rev 1.1APP

1756HP-CNV USER MANUAL - Hiprom

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?