Reece ™ | Plumbing | Auspex | Pushfit Manual

INSTALLATION INSTRUCTIONSStep 1Cut the pipe squarely in the middleof the witness mark on the pipeusing secateur type cutters. (Do notuse a hacksaw). This is importantso that when a joint is made, thepipe has penetrated to the full depthof the socket. For pipes that donot have a witness mark, use theWitness Mark Gauge available fromyour supplier.If the pipe is not witness markedand a gauge is not available,measure the depth of the socketand apply your own witness mark tothe pipe. 16mm witness mark length= 24.5mm-20mm witness marklength = 28.00mm.As with any “O” ring joint, theexternal surface of the productin contact with “O” ring will effectthe joint performance. Checkfor imperfections before cutting.The end of the pipe may need tobe freshly cut to ensure smoothpassage for the fitting.IMPORTANT:It is vital that thereis no threat to theperformance of the “O”ring. Check for scratches,sand, mud, etc on pipeor within fitting beforeassembly, as theseconditions mayaffect the integrityof the system.Step 2Ensure the pipe has a square cutand has no rough edges or externaldamage eg. scratches that maydamage the “O” ring.Step 3If the fitting does not have a supportsleeve, insert a SUPPORT SLEEVEpushing fully home.2PERFECT FIT